Selectivity of alkylamide bonded-phases with respect to organic acids under reversed-phase conditions

T Czajkowska1, M Jaroniec

  • 1American Cyanamid Company, Agricultural Products Research Division, Princeton, NJ 08543-0400, USA.

Related Concept Videos

Regioselectivity of Electrophilic Additions to Alkenes: Markovnikov's Rule02:20

Regioselectivity of Electrophilic Additions to Alkenes: Markovnikov's Rule

If a set of reactants can yield multiple constitutional isomers, but one of the isomers is obtained as the major product, the reaction is said to be regioselective. In such reactions, bond formation or breaking is favored at one reaction site over others.
The hydrohalogenation of an unsymmetrical alkene can yield two haloalkane products, depending on which vinylic carbon takes up the halogen. However, one product usually predominates, where hydrogen adds to the vinylic carbon bearing the...
Regioselectivity and Stereochemistry of Acid-Catalyzed Hydration02:34

Regioselectivity and Stereochemistry of Acid-Catalyzed Hydration

The rate of acid-catalyzed hydration of alkenes depends on the alkene's structure, as the presence of alkyl substituents at the double bond can significantly influence the rate.
Relative Reactivity of Carboxylic Acid Derivatives01:13

Relative Reactivity of Carboxylic Acid Derivatives

Carboxylic acid derivatives such as acid halides, anhydrides, esters, and amides undergo nucleophilic acyl substitution reactions with varying degrees of reactivity.
A key factor in assessing the reactivity of the acid derivatives is the basicity of the substituent or the leaving group. The lower the basicity of the leaving group, the higher the reactivity of the derivative. The basicity of the leaving group follows this order:
Halide ions < Acyloxy ions < Alkoxy ions < Amine ions
Basicity of Aliphatic Amines01:21

Basicity of Aliphatic Amines

Amines can behave as Brønsted–Lowry bases by accepting a proton from the acid to form corresponding conjugate acids. Due to a lone pair of nonbonding electrons, aliphatic amines can also act as Lewis bases by forming a covalent bond with an electrophile.
To measure the basicity of amines, two conventions are generally used. The first defines Kb as the basicity constant for the deprotonation reaction of water by the amine, as presented in Figure 1. Conventionally, lower Kb indicates higher...
Physical Properties of Carboxylic Acid Derivatives01:19

Physical Properties of Carboxylic Acid Derivatives

Intermolecular forces dictate several physical properties such as boiling points, melting points, solubilities, and so forth. They are classified into four types: ionic forces, hydrogen bonds, dipole–dipole forces, and dispersion forces. Ionic forces are the strongest, while dispersion forces are the weakest.
Among the carboxylic acid derivatives, the boiling points of acid chlorides and esters are very similar and are the lowest in the series. Acid anhydrides have slightly higher boiling...
Factors Affecting &alpha;-Alkylation of Ketones: Choice of Base01:10

Factors Affecting α-Alkylation of Ketones: Choice of Base

α-Alkylation of ketones is achieved in the presence of alkyl halides and a base. The reaction proceeds via the formation of an enolate ion followed by nucleophilic substitution. The choice of base employed is essential as it is the key factor in determining the reaction outcome.
The reaction involving bases like EtO− whose conjugate acid EtOH (pKa = 15.9) is stronger than the ketone (pKa = 19.2) results in an equilibrium mixture with higher ketone concentration. As a consequence, side reactions...