Related Experiment Video
Updated: Sep 22, 2026

Mimicking and Measuring Occlusal Erosive Tooth Wear with the "Rub&Roll" and Non-contact Profilometry
Published on: February 2, 2018
Clinical and laboratory evaluation of powered electric toothbrushes: relative degree of bristle end-rounding
Abstract:
Toothbrush bristles with sharp edges have been postulated to represent a greater threat to dental tissues than end-rounded bristles. This study evaluated the effect of both in vivo and laboratory use on bristle wear rate, tip geometry and in vitro abrasivity. Three soft manual brushes (Oral-B P40, Crest Complete and Butler GUM) and one powered brush (Rota-dent) were tested. The results of this study show that the wear rate varied directly with brushing load and amount of dentifrice, and inversely with bristle diameter. Despite the initial geometry, a flat tip with rounded rims was typically observed after only 30 minutes of manual or Rota-dent brush use. There was no statistical difference in in vitro abrasion for new brushes versus used brushes.

