Film thickness of various dentine bonding agents

Curing dentine bonding agents create a film thickness on the surface of teeth which are prepared for all-ceramic crowns. The aim of this study was to investigate if the film thickness of dentine bonding agents (DBAs) is acceptable with the fit of definitive restorations of 50-100 microm. AllBond 2, Syntac, ART Bond, P-Bond (an experimental DBA), and the Primer of AllBond 2 were applied onto teeth which were prepared with standardized all-ceramic crown preparations. The DBAs were applied onto the prepared tooth surfaces according to manufacturers' instructions and under a standardized simulation of intrapulpal pressure. After curing the DBAs, the teeth were cut mesiodistally and orolingually and the film thickness was measured under a light microscope. Only the film thicknesses of AllBond 2 and P-Bond were low enough and, therefore, would enable curing to take place immediately after their application.