Selection and evaluation of blood- and tribologically compatible journal bearing materials

A critical issue in the Cleveland Clinic Foundation (CCF) Innovative Ventricular Assist System (IVAS) blood pump is the selection of materials for the blood-lubricated journal bearing. Under normal operating conditions, the journal bearing geometry creates a thick blood film that separates the rotating and stationary surfaces. However, since start-up and certain transients could cause temporary contact, the material pair selected for these surfaces must be both tribologically and blood compatible. Combinations of two biocompatible alloys were tested: a titanium-zirconium-niobium alloy (Ti-13Zr-13Nb) and a zirconium-niobium alloy (Zr-2.5Nb). A standard pin-on-disk tester was used, with the contact surfaces lubricated by glycerol/saline mixtures simulating the viscosity range of blood. One test series evaluated start-up conditions; the other modeled a high-speed rub that might occur if the fluid film broke down. Results showed that the preoxidized Zr-2.5Nb pin/Ti-13Zr-13Nb disk combination was superior at all sliding velocities; a self-mated Zr-2.5Nb pair also showed promise. The oxide film on a self-mated Ti-13Zr-13Nb pair, and a Ti-13Zr-13Nb pin and Zr-2.5Nb disk combination did not show adequate wear life. More work remains to explain distinct performance differences of certain combinations, with more data needed on mechanical properties of thin, hard coatings on softer metal substrates.