Related Experiment Video
Updated: Aug 6, 2026

Determining the Contribution of the Energy Systems During Exercise
Published on: March 20, 2012
A comparison of active and passive warm ups on energy system contribution and performance in moderate heat
1School of Human Movement and Sport Sciences, University of Ballarat, Australia.
Abstract:
The effect of either an active warm up (AWU) or a passive warm up (PWU) on performance and energy system contribution in a moderately hot ambient environment (30 degrees C, 50% Relative humidity) was investigated. The AWU procedure involved exercise at 100% VO2 max followed by four 30 sec efforts at 100% of VO2 max and the PWU involved the application of heat pads to the quadriceps for 60 min. Following either warm up procedure, (randomized cross over design) a 60 s supramaximal test on a Monark bicycle ergometer was performed. The AWU procedure elicited the greatest average power output (0-30 s: 669 +/- 28 W vs 645 +/- 30 W, p < 0.05) and (0-60 s 529 +/- 20 W vs 513 +/- 20 W, p < 0.05), the greatest peak power output (917 +/- 45 W vs 880 +/- 46 W, p < 0.01) and VO2 peak during the initial 30 s (1.4 +/- 0.1 vs 1.2 +/- 0.1 l.min-1, p < 0.01) and over the duration of the 60 s test (3.2 +/- 0.1 vs 2.9 +/- 0.2 l.min-1, p < 0.05). The estimated anaerobic energy release was not significantly different between the trials. The performance benefits of an AWU occurred within the first 30 s of exercise as there was no significant differences in average power output or VO2 peak in the final 30 s of exercise. In conclusion, an AWU enhances sprinting performance in a moderately hot ambient environment, despite a higher rectal temperature than a PWU. The increased power output is derived from greater oxygen consumption in the initial stages of exercise.
More Related Videos
Related Concept Videos
Pulmonary Tuberculosis I
Causative Organism
The primary infectious agent causing tuberculosis is Mycobacterium tuberculosis, a slow-growing, acid-fast, aerobic rod that exhibits sensitivity to heat and ultraviolet light. Instances of Mycobacterium bovis and Mycobacterium avium contributing to the development of TB infection are rare.
Mode of...
Pulmonary Tuberculosis II
Here is a detailed explanation of its pathophysiology:
Transmission: The process begins when a person inhales droplet nuclei containing M. tuberculosis. These are typically released into the air when an individual with pulmonary or...
Pulmonary Tuberculosis III
The first classification is based on the development of the disease, and it includes the following categories:
Pulmonary Tuberculosis IV
Several diagnostic approaches are used to detect TB. The conventional method is the Tuberculin Skin Test (TST), also known as the Mantoux test. However, this method has...
Pulmonary Tuberculosis V
Latent tuberculosis infection occurs when TB bacteria are present in a person's body, but are not causing illness or symptoms. It is not contagious, and preventive treatment is crucial to avoid the progression...

