The response of a MOSFET, p-type semiconductor and LiF TLD to quasi-monoenergetic x-rays
Related Experiment Video
Updated: Oct 30, 2026

Carrier Lifetime Measurements in Semiconductors through the Microwave Photoconductivity Decay Method
Published on: April 18, 2019
C R Edwards1, S Green, J E Palethorpe
1Department of Biomedical Engineering and Medical Physics, North Staffordshire Hospital (Royal Infirmary), Stoke-on-Trent, UK.
Abstract:
A metal oxide semiconductor field effect transistor (MOSFET), p-type semiconductor and a TLD can all be used for x-ray dosimetry, with each system having the common disadvantage of a response which is dependent upon the incident photon energy, particularly for energies < 1 MeV. A Pantak HF-320 quasi-monoenergetic x-ray unit was used to determine the response of two Thomson and Nielson TN-502RD MOSFETs, a Scanditronix EDP-10 semiconductor (build-up cap 10 mm: tissue equivalence), an EDD-5 semiconductor (build-up cap 4.5 mm: tissue equivalence) and an Lif:Mg:Ti TLD over the energy range 12-208 keV. The sensitivity of each detector was normalized to the value produced by exposure to 6 MV x-rays. The maximum relative sensitivities of the two MOSFET detectors were 4.19 +/- 0.25 and 4.44 +/- 0.26 respectively, occurring at an incident x-ray energy of 33 keV. The maximum relative sensitivity of the Scanditronix EDP-10 of 2.24 +/- 0.13 occurred at 65 keV, and for the EDD-5, it was 7.72 +/- 0.45 at 48 keV. The TLD produced a maximum relative sensitivity of 1.31 +/- 0.09 at 33 keV. Compared with available data based on heteroenergetic x-ray sources, these measurements have identified a more representative response for each detector to low-energy x-rays.
Related Concept Videos
Characteristics of MOSFET
Various vital parameters influence their functionality, which is crucial for theory and electronics applications. First, channel dimensions, precisely length, and width, are pivotal. The size of these channels affects the transistor's ability to carry current and switching speeds; shorter channels typically enable quicker...
MOSFET
In an n-MOSFET, the structure includes n-type source and drain...
MOSFET: Enhancement Mode
In their basic form, enhancement-mode MOSFETs are typically non-conductive when the gate-source voltage (Vgs) is zero. This default 'off' state means no current...
MOSFET Amplifiers
Metal-Semiconductor Junctions
Schottky Barriers
Schottky barriers arise when a metal with a work function (Φm) contacts a semiconductor with a different work function (Φs). Initially, electrons transfer until the Fermi levels of the metal and semiconductor align at equilibrium. For instance, if Φm > Φs, the semiconductor Fermi level is higher than the metal's before contact. The semiconductor's...
MOSFET: Depletion Mode
The primary characteristic of depletion-mode MOSFETs is their ability to conduct current between the drain and source terminals without gate bias. This inherent conductivity arises...

