Structural characteristics of corn starches extruded with soy protein isolate or wheat gluten

Commercially available corn starches containing 0, 25, 50 and 70% amylose were extruded with 10, 20 and 30% soy protein isolate (SPI) or wheat gluten (WG) at 22% moisture content (dry basis) in a C.W. Brabender single screw laboratory extruder using a 140 degrees C barrel temperature and a 140 rpm screw speed. True, solid and bulk densities; percent total, closed and open pores; and shear strengths of the extrudates were determined. The microstructures of the extrudates were studied by scanning electron microscopy (SEM). The total pores of the extrudates were affected significantly (p > F = 0.0001) by type of protein (SPI or WG) and starch amylose. The open or closed pores, were affected by protein type only. The interaction between amylose and protein contents was highly significant (p > F = 0.0001). In general, the total pores and bulk densities were higher for WG-starch extrudates compared to SPI-starch extrudates. These values decreased as amylose content increased from 0 to 25% and then increased thereafter. The open pores, on the other hand, increased with increasing protein content from 10 to 20% and then decreased. Extrudates containing WG had higher shear strengths than those containing SPI.