Gas-liquid chromatography of nucleosides. Derivatization and chromatography

The aims of this investigation were to establish the optimum reaction conditions for silylation of nucleotides with bis(trimethylsilyl)trifluoroacetamide (BSTFA) and to investigate the chromatographic properties of the following nucleosides: adenosine, guanosine, cytidine, thymine, inosine, xanthosine, and uridine. Closed tube silylations were performed with a 1000 molar excess of BSTFA at 25, 75, 120, 150, and 175 degrees for 15, 30, 60, 120 and 240 min. The optimal time and temperature for derivatization were found to be 150 degrees and 15 min. Using these reaction conditions, samples were then silylated with 50, 100, 200, 500, and 1000 molar excess of BSTFA; a molar excess of 225 was best. The stability of the nucleoside derivatives on standing at room temperature for 1-7 days was investigated. Quantitative gas-liquid chromatography of trimethylsilyl (TMS) nucleosides can be performed if samples are analyzed within 48 h, after which time the relative weight response for the nucleosides decreased somewhat. Chromatographic column studies were made using various liquid phases and supports. With methylsiloxanes as the liquid phase, Supelcoport as support was found to be superior. Resolution of TMS guanosine from TMS cytidine was attempted at different column lengths using 3% (w/w) SE-30 on Supelcoport, different loadings (%, w/w) of SE-30 on Supelcoport, and different polarity liquid phases, 4% (w/w) OV-11 or 3% (w/w) OV-17 or 4% (w/w) Dexsil-300 on Supelcoport. A complete separation of the six ribonucleosides including guanosine and cytidine was obtained with 1 m x 4 mm I.D. glass columns of 4% (w/w) OV-11 and 3% (w/w) OV-17 on 100-120 mesh Supelcoport. It was observed that with 2'-deoxycytidine, one obtains the TMS cytosine peak (retention temperature 150 degrees) plus another peak with a retention temperature of 120 degrees, under all derivatization conditions with BSTFA and bis(trimethylsilyl)-acetamide. Similar formation of bases from other 2'-deoxyribonucleosides occurred when the molar excess of BSTFA was greater than 500. The minimal detectable amounts obtained for all the nucleosides ranged from 5 to 10 ng injected with a signal-to-noise ratio of 3. The relative standard deviations for all nucleosides and deoxynucleosides ranged from 1.2 to 4.8% on different methylsiloxanes on Supelcoport columns.