Digital radiology using active matrix readout of amorphous selenium: detectors with high voltage protection

A flat-panel x-ray imaging detector is being investigated for digital radiography and fluoroscopy. The detector uses a layer of amorphous selenium (a-Se) to convert x rays to a charge image, which is then electronically read out with a two-dimensional array of thin film transistors (TFTs). In order to sensitize the a-Se layer to x rays, a high voltage (of the order of several thousand volts) is applied to its top surface. The TFTs, which are at the bottom surface of the a-Se layer, are not subjected to any high voltage under normal radiological operational conditions since the pixel potential is < 10 V. However under a fault condition where these two events occur simultaneously: (1) suspended detector scan; and (2) an x-ray exposure more than ten times higher than normal, the voltage on the TFTs could rise to a damaging value. This paper describes a method for protecting the TFTs from high voltage damage under this fault condition. It employs a dual-gate TFT structure, one gate is for scanning control and the other is connected to the pixel electrode for high voltage protection. Before the pixel potential reaches a damaging value, the protection gate turns on the TFT automatically and drains excess charge away from the pixel thus providing a safe pixel saturation potential. In this paper, the characteristic curves of dual-gate TFTs are studied both theoretically and experimentally. The pixel x-ray response for imaging detectors with high voltage protection are predicted, and it is shown that with practical TFT designs the detector can provide a safe pixel saturation potential as well as satisfy the dynamic range required for diagnostic x-ray imaging applications.