Calculation of electric fields and currents induced in a millimeter-resolution human model at 60 Hz using the FDTD...

The finite-difference time-domain (FDTD) method has previously been used to calculate induced currents in anatomically based models of the human body at frequencies ranging from 20 to 915 MHz and resolutions down to about 1.25 cm. Calculations at lower frequencies and higher resolutions have been precluded by the huge number of time steps that would be needed in these simulations. This paper describes a method used to overcome this problem and efficiently calculate induced currents in an MRI-based, 6-mm-resolution model of the human under a high-voltage transmission line. This model is significantly higher resolution than the 1.31-cm-resolution model previously used; therefore, it can be used to pinpoint locations of peak current densities in the body. Proposed safety guidelines would allow external electric fields of 10 kV/m and 25 kV/m for exposure to 60 Hz fields of the general public and workers, respectively. For this external electric field exposure of 10 kV/m, local induced current densities as high as 20 mA/m2 are found in the head and trunk with even higher values (above 150 mA/m2) in the legs. These currents are considerably higher than the 4 or even 10 mA/m2 that have been suggested in the various safety guidelines, thus indicating an inconsistency in the proposed guidelines. In addition, several ratios of E/H typical of power line exposures were examined, and it was found that the vertical electric field couples strongly to the body, whereas the horizontal magnetic field does not.