Determination of metal ions in algal solution samples by capillary electrophoresis

Trace metals determination in aqueous samples can be readily accomplished by capillary electrophoresis (CE) via indirect absorbance detection. A method for the separation of metal ions is presented and applied to the determination of seven metals in algal solution samples. 2-Hydroxyisobutyric acid background electrolyte (BGE) containing UV CAT-1 (an ultraviolet-absorbing amine) is used to perform capillary ion analysis. Acetic acid is used to adjust the pH value of BGE to 4.4. All ions can be separated in less than 15 min. All peaks are well separated and baseline resolved (i.e., no peaks overlapped). This work presents the applicability of CE to the quantitative analysis of algal solution samples and shows the adsorption process of seven metals in solution (Mn, Cd, Cr, Ni, Zn, Pb, Cu) to Chlorella vulgaris. The innovation of the application of CE in the determination of metals bound by Chlorella vulgaris is shown to be an improvement of the pH over what has been published previously. The detection limit is in the range of 13 (Mn) to 102 (Pb) ppb with electrokinetic injection mode (15 kV, 7 s). Reproducibility was 1.4% for the migration time, better than 5% for peak area for four of the metal ions (Cr, Mn, Cd, and Cu), and lower than 5% for the other three (Ni, Zn, and Pb). Calibration curves are linear for most ions in the 10(-7)-10(-5)M range (correlation coefficient r2 = 0.9933-0.9986) using electrokinetic injection mode.