Bone augmentation at titanium implants using autologous bone grafts and a bioresorbable barrier. An experimental...

The aim of the present investigation was to compare the effect of using autologous bone particles covered with a bioresorbable matrix barrier with the use of bone particles alone on bone augmentation at titanium implants installed in the rabbit tibia. Two Brånemark System implants, one in each tibia, were inserted in each of 9 rabbits in such a way that 5 threads were not covered with bone. Autologous bone particles were harvested from the skull and placed over the exposed implant surfaces on each tibia. The bone graft on one tibia was covered with a Guidor Matrix Barrier, while the bone graft on the other tibia served as a control. After a healing period of 12 weeks, the animals were sacrificed and specimens taken for histomorphometrical analyses. The analyses showed that a significantly larger volume of augmented bone tissue had formed at the test sites. There were, however, no differences in the amount of mineralized bone. In fact, the difference in tissue volume was due to an increased amount of bone marrow at the test sites. The degree of mineralized bone to implant contact as well as the degree of mineralized bone within the threads at the test implants were similar to that at the controls. In conclusion, it was found that the coverage of particulate autologous bone grafts with a bioresorbable barrier resulted in a larger volume of augmented bone than the use of bone grafts not covered with a barrier.