Nonfluoroscopic localization of an amagnetic catheter in a realistic torso phantom by magnetocardiographic and body...

This study was performed to evaluate the accuracy of multichannel magnetocardiographic (MCG) and body surface potential mapping (BSPM) in localizing three-dimensionally the tip of an amagnetic catheter for electrophysiology without fluoroscopy. An amagnetic catheter (AC), specially designed to produce dipolar sources of different geometry without magnetic disturbances, was placed inside a physical thorax phantom at two different depths, 38 mm and 88 mm below the frontal surface of the phantom. Sixty-seven MCG and 123 BSPM signals generated by the 10 mA current stimuli fed into the catheter were then recorded in a magnetically shielded room. Non-invasive localization of the tip of the catheter was computed from measured MCG and BSPM data using an equivalent current dipole source in a phantom-specific boundary element torso model. The mean 3-dimensional error of the MCG localization at the closer level was 2 +/- 1 mm. The corresponding error calculated from the BSPM measurements was 4 +/- 1 mm. At the deeper level, the mean localization errors of MCG and BSPM were 7 +/- 4 mm and 10 +/- 2 mm, respectively. The results showed that MCG and BSPM localization of the tip of the AC is accurate and reproducible provided that the signal-to-noise ratio is sufficiently high. In our study, the MCG method was found to be more accurate than BSPM. This suggests that both methods could be developed towards a useful clinical tool for nonfluoroscopic 3-dimensional electroanatomical imaging during electrophysiological studies, thus minimizing radiation exposure to patients and operators.