Related Experiment Video

Updated: Jul 28, 2026

Measurement of Coherence Decay in GaMnAs Using Femtosecond Four-wave Mixing
15:58

Measurement of Coherence Decay in GaMnAs Using Femtosecond Four-wave Mixing

Published on: December 3, 2013

Cyclotron-resonance-induced photovoltage of inversion electrons on GaAs

Thiele, Batke, Dolgopolov

    Physical Review. B, Condensed Matter
    |July 15, 1989
    PubMed
    Abstract

    No abstract available in PubMed .

    More Related Videos

    High Resolution Phonon-assisted Quasi-resonance Fluorescence Spectroscopy10:40

    High Resolution Phonon-assisted Quasi-resonance Fluorescence Spectroscopy

    Published on: June 28, 2016

    Resonance Fluorescence of an InGaAs Quantum Dot in a Planar Cavity Using Orthogonal Excitation and Detection12:57

    Resonance Fluorescence of an InGaAs Quantum Dot in a Planar Cavity Using Orthogonal Excitation and Detection

    Published on: October 13, 2017

    Related Concept Videos

    Photoelectric Effect02:26

    Photoelectric Effect

    When light of a particular wavelength strikes a metal surface, electrons are emitted. This is called the photoelectric effect. The minimum frequency of light that can cause such emission of electrons is called the threshold frequency, which is specific to the metal. Light with a frequency lower than the threshold frequency, even if it is of high intensity, cannot initiate the emission of electrons. However, when the frequency is higher than the threshold value, the number of electrons ejected...
    Photochemical Electrocyclic Reactions: Stereochemistry01:26

    Photochemical Electrocyclic Reactions: Stereochemistry

    The absorption of UV–visible light by conjugated systems causes the promotion of an electron from the ground state to the excited state. Consequently, photochemical electrocyclic reactions proceed via the excited-state HOMO rather than the ground-state HOMO. Since the ground- and excited-state HOMOs have different symmetries, the stereochemical outcome of electrocyclic reactions depends on the mode of activation; i.e., thermal or photochemical.
    Selection Rules: Photochemical Activation
    Induced Electric Dipoles01:29

    Induced Electric Dipoles

    A permanent electric dipole orients itself along an external electric field. This rotation can be quantified by defining the potential energy because the external torque does work in rotating it. Then, the potential energy is minimum at the parallel configuration and maximum at the antiparallel configuration. While the former is a stable equilibrium, the latter is an unstable equilibrium.
    Since the absolute value of potential energy holds no physical meaning, its zero value can be chosen as per...
    Deactivation Processes: Jablonski Diagram01:25

    Deactivation Processes: Jablonski Diagram

    Luminescence, the emission of light by a substance that has absorbed energy, is a process that involves the interaction of molecules with light. The energy-level diagram, or Jablonski diagram, is a graphical representation of these interactions, illustrating the various states and transitions a molecule can undergo. In a typical Jablonski diagram, the lowest horizontal line represents the ground-state energy of the molecule, which is usually a singlet state. This state represents the energies...
    Inductively Coupled Plasma Atomic Emission Spectroscopy: Principle01:19

    Inductively Coupled Plasma Atomic Emission Spectroscopy: Principle

    Inductively coupled plasma (ICP) is the most widely used plasma source in atomic emission spectroscopy (AES), also known as Inductively Coupled Plasma Optical Emission Spectroscopy (ICP-OES). The ICP source, or torch, consists of three concentric quartz tubes with argon gas flowing through them. A spark from a Tesla coil initiates the ionization of argon, generating a high-temperature plasma.
    The ions and electrons produced interact with the fluctuating magnetic field created by a water-cooled...
    Carrier Generation and Recombination01:22

    Carrier Generation and Recombination

    Carrier generation is the process by which electron-hole pairs (EHPs) are created within the semiconductor. In direct-bandgap semiconductors, such as gallium arsenide (GaAs), this occurs efficiently when energy absorption prompts valence electrons to leap into the conduction band, leaving behind holes.
    This process is given by the generation rate G and is efficient due to the conservation of momentum between the valence band maximum and conduction band minimum.
    Indirect generation involves an...