Showing results (1-10 of 42) with videos related to

Sort By:
Pageof 5
Polymers|February 10, 2024
Epoxy-Based Blend Formulation for Dual Curing in Liquid Crystal Display 3D Printing: A Study on Thermomechanical Properties Variation for Enhanced PrintabilityClaudio Tosto, Lorena Saitta, Alberta Latteri, et al.
Polymers|June 20, 2019
Interlaminar Toughening of Epoxy Carbon Fiber Reinforced Laminates: Soluble Versus Non-Soluble VeilsGiulia Ognibene, Alberta Latteri, Salvatore Mannino, et al.
Polymers|September 30, 2020
Influence of the Processing Conditions on the Mechanical Performance of Sustainable Bio-Based PLA CompoundsAntonella Patti, Domenico Acierno, Alberta Latteri, et al.
Polymers|June 28, 2023
A Regression Approach to Model Refractive Index Measurements of Novel 3D Printable Photocurable Resins for Micro-Optofluidic ApplicationsLorena Saitta, Emanuela Cutuli, Giovanni Celano, et al.
Polymers|August 10, 2021
Microstructured Surface Plasmon Resonance Sensor Based on Inkjet 3D Printing Using Photocurable Resins with Tailored Refractive IndexNunzio Cennamo, Lorena Saitta, Claudio Tosto, et al.
Materials (Basel, Switzerland)|August 29, 2017
Green Composites Based on Blends of Polypropylene with Liquid Wood Reinforced with Hemp Fibers: Thermomechanical Properties and the Effect of Recycling CyclesGianluca Cicala, Claudio Tosto, Alberta Latteri, et al.
Polymers|July 14, 2023
Chemical Recycling of Fully Recyclable Bio-Epoxy Matrices and Reuse Strategies: A Cradle-to-Cradle ApproachLorena Saitta, Giuliana Rizzo, Claudio Tosto, et al.
Polymers|November 25, 2023
Projection Micro-Stereolithography to Manufacture a Biocompatible Micro-Optofluidic Device for Cell Concentration MonitoringLorena Saitta, Emanuela Cutuli, Giovanni Celano, et al.
Polymers|May 28, 2022
3D Printing Manufacturing of Polydimethyl-Siloxane/Zinc Oxide Micro-Optofluidic Device for Two-Phase Flows ControlGiovanna Stella, Matteo Barcellona, Lorena Saitta, et al.
Entropy (Basel, Switzerland)|May 28, 2022
Specific Heat Capacity and Thermal Conductivity Measurements of PLA-Based 3D-Printed Parts with Milled Carbon Fiber ReinforcementIgnazio Blanco, Gianluca Cicala, Giuseppe Recca, et al.
Pageof 5