Showing results (11-20 of 76) with videos related to
Sort By:
Pageof 8
Polymers|September 28, 2023
Limitations of the Check Calculation for Tooth Deformation of Plastic Gears According to Gear Design Guideline VDI 2736Christoph Herzog, Dietmar DrummerPolymers|August 12, 2022
The Impact of β-Radiation Crosslinking on Flammability Properties of PA6 Modified by Commercially Available Flame-Retardant AdditivesFlorian Tomiak, Dietmar DrummerPolymers|September 28, 2021
Process Behavior of Short Glass Fiber Filled Systems during Powder Bed Fusion and Its Effect on Part DimensionsLydia Lanzl, Dietmar DrummerPolymers|September 28, 2021
A Dyciandiamine-Based Methacrylate-Epoxy Dual-Cure Blend-System for StereolithographyManuel Romeis, Dietmar DrummerPolymers|May 14, 2020
Curing Kinetic Analysis of Acrylate Photopolymer for Additive Manufacturing by Photo-DSCFengze Jiang, Dietmar DrummerPolymers|November 6, 2019
Influence of Filler Content and Filler Size on the Curing Kinetics of an Epoxy ResinYang Zhao, Dietmar DrummerPolymers|July 30, 2025
Correlation of the Thermal Conductivity and Mechanical Properties in Hybrid Filler Systems of ThermosetsUta Rösel, Dietmar DrummerPolymers|April 23, 2022
Two Layer Sheets for Processing Post-Consumer MaterialsLisa-Maria Wittmann, Dietmar DrummerPolymers|April 10, 2019
Nonlinear Material Model for Quasi-Unidirectional Woven Composite Accounting for Viscoelastic, Viscous Deformation, and Stiffness ReductionZhanyu Zhai, Bingyan Jiang, Dietmar DrummerPolymers|April 11, 2019
Thermal Conductivity of Aluminosilicate- and Aluminum Oxide-Filled Thermosets for Injection Molding: Effect of Filler Content, Filler Size and Filler GeometryYang Zhao, Zhanyu Zhai, Dietmar DrummerPageof 8