Jove
Visualize
Contáctanos
JoVE
x logofacebook logolinkedin logoyoutube logo
ACERCA DE JoVE
Visión GeneralLiderazgoBlogCentro de Ayuda JoVE
AUTORES
Proceso de PublicaciónConsejo EditorialAlcance y PolíticasRevisión por ParesPreguntas FrecuentesEnviar
BIBLIOTECARIOS
TestimoniosSuscripcionesAccesoRecursosConsejo Asesor de BibliotecasPreguntas Frecuentes
INVESTIGACIÓN
JoVE JournalMethods CollectionsJoVE Encyclopedia of ExperimentsArchivo
EDUCACIÓN
JoVE CoreJoVE BusinessJoVE Science EducationJoVE Lab ManualCentro de Recursos para ProfesoresSitio de Profesores
Términos y Condiciones de Uso
Política de Privacidad
Políticas

Videos de Conceptos Relacionados

Mixtures of Acids03:27

Mixtures of Acids

The pH of a solution containing an acid can be determined using its acid dissociation constant and its initial concentration. If a solution contains two different acids, then its pH can be determined using one of several methods depending upon the relative strength of the acids and their dissociation constants.
A Mixture of a Strong Acid and a Weak Acid
In a mixture of a strong acid and a weak acid, the strong acid dissociates completely and becomes a source of almost all the hydronium ions...
¹³C NMR: ¹H–¹³C Decoupling01:04

¹³C NMR: ¹H–¹³C Decoupling

The probability of having two carbon-13 atoms next to each other is negligible because of the low natural abundance of carbon-13. Consequently, peak splitting due to carbon-carbon spin-spin coupling is not observed in spectra. However, protons up to three sigma bonds away split the carbon signal according to the n+1 rule, resulting in complicated spectra.
A broadband decoupling technique is used to simplify these complex, sometimes overlapping, signals. Broadband decoupling relies on a...
Precipitation Processes01:12

Precipitation Processes

The experimental conditions in a gravimetric analysis should be optimized to maximize the particle size and purity of the obtained precipitate. Ideally, the concentration of the precipitating reagent should be low with effective stirring to maintain low relative supersaturation for the growth of large crystals. In homogeneous precipitation, the precipitant is slowly generated by a chemical reaction in the solution to avoid local reagent excesses. For example, urea decomposes gradually to...
Colloidal precipitates01:09

Colloidal precipitates

The high insolubility of some precipitates can result in an unfavorable relative supersaturation. This can lead to colloidal particles with a large surface-to-mass ratio, where adsorption is promoted. For instance, in the precipitation of silver chloride, silver ions are adsorbed on the surface of the colloidal particles, forming a primary layer. This layer attracts ions of opposite charge (such as nitrate ions), forming a diffuse secondary layer of adsorbed ions. This electric double layer...
Heterogeneous Catalysis01:22

Heterogeneous Catalysis

Heterogeneous catalysis involves a catalyst in a different phase from the reactants. It is a process where the catalyst and the reactants are in distinct phases, typically solid and gas or liquid.Most heterogeneous catalysts are metals, metal oxides, or acids. The list includes transition metals like iron (Fe), cobalt (Co), nickel (Ni), palladium (Pd), platinum (Pt), chromium (Cr), manganese (Mn), tungsten (W), silver (Ag), and copper (Cu). These metals possess partially vacant d orbitals that...
Superplasticizers01:30

Superplasticizers

Superplasticizers are advanced admixtures that enhance the workability of concrete by lowering the water content without compromising the strength of the material. These substances are highly effective water reducers, improving concrete flow, making it easier to work with, and enabling concrete to reach inaccessible areas or densely reinforced sections without mechanical vibration. The key components in superplasticizers are either sulfonated melamine or naphthalene formaldehyde condensates,...

También podría leer

Artículos Relacionados

Artículos vinculados a este trabajo por autores compartidos, revista y gráfico de citas.

Ordenar por
Same author

Entropic characterization of the coil-stretch transition of polymers in random flows.

Physical review. E·2021
Same author

A low-cost low-maintenance ultraviolet lithography light source based on light-emitting diodes.

Lab on a chip·2014
Same author

What is vinculin needed for in platelets?

Journal of thrombosis and haemostasis : JTH·2010
Same author

Dynamics of a vesicle in general flow.

Proceedings of the National Academy of Sciences of the United States of America·2009
Same author

Phase diagram of single vesicle dynamical states in shear flow.

Physical review letters·2009
Same author

Shear instability in fluids with a density-dependent viscosity.

Physical review letters·2008

Video Experimental Relacionado

Updated: Jun 19, 2026

Synthesis of Immunotargeted Magneto-plasmonic Nanoclusters
09:43

Synthesis of Immunotargeted Magneto-plasmonic Nanoclusters

Published on: August 22, 2014

Mezclado eficiente a bajos números de Reynolds utilizando aditivos poliméricos.

A Groisman1, V Steinberg

  • 1Department of Physics of Complex Systems, The Weizmann Institute of Science, 76100 Rehovot, Israel.

Nature
|April 20, 2001
PubMed
Resumen

Este estudio muestra que agregar una pequeña cantidad de polímeros a líquidos viscosos puede mezclarlos de manera eficiente a números muy bajos de Reynolds. Este descubrimiento ofrece un nuevo método para la mezcla de fluidos en diversas aplicaciones.

Más Videos Relacionados

Flash NanoPrecipitation for the Encapsulation of Hydrophobic and Hydrophilic Compounds in Polymeric Nanoparticles
10:12

Flash NanoPrecipitation for the Encapsulation of Hydrophobic and Hydrophilic Compounds in Polymeric Nanoparticles

Published on: January 7, 2019

Application of a Coupling Agent to Improve the Dielectric Properties of Polymer-Based Nanocomposites
06:34

Application of a Coupling Agent to Improve the Dielectric Properties of Polymer-Based Nanocomposites

Published on: September 19, 2020

Videos de Experimentos Relacionados

Last Updated: Jun 19, 2026

Synthesis of Immunotargeted Magneto-plasmonic Nanoclusters
09:43

Synthesis of Immunotargeted Magneto-plasmonic Nanoclusters

Published on: August 22, 2014

Flash NanoPrecipitation for the Encapsulation of Hydrophobic and Hydrophilic Compounds in Polymeric Nanoparticles
10:12

Flash NanoPrecipitation for the Encapsulation of Hydrophobic and Hydrophilic Compounds in Polymeric Nanoparticles

Published on: January 7, 2019

Application of a Coupling Agent to Improve the Dielectric Properties of Polymer-Based Nanocomposites
06:34

Application of a Coupling Agent to Improve the Dielectric Properties of Polymer-Based Nanocomposites

Published on: September 19, 2020

Área de la Ciencia:

  • La mecánica de fluidos es la mecánica de fluidos.
  • Reología Reología.
  • Física de los polímeros La física de los polímeros es la física de los polímeros.

Sus antecedentes:

  • La mezcla eficiente de fluidos es crucial para los procesos industriales y ambientales.
  • La mezcla a bajos números de Reynolds (flujo laminar) suele ser ineficiente sin equipo especializado.
  • Existen soluciones analíticas para la mezcla para regímenes específicos de flujo aleatorio, como el régimen de Batchelor.

Objetivo del estudio:

  • Para investigar experimentalmente la mezcla eficiente de líquidos viscosos a bajos números de Reynolds.
  • Explorar el papel de los polímeros de alto peso molecular en la mejora de la mezcla de fluidos.
  • Para validar las predicciones teóricas dentro del régimen de mezcla de Batchelor.

Principales métodos:

  • Utilizando una configuración simple de flujo de canal curvo.
  • Empleando líquidos muy viscosos con una concentración mínima (0.001%) de polímeros de alto peso molecular.
  • Realización de observaciones experimentales detalladas de mezcla de fluidos y patrones de flujo.

Principales resultados:

  • Se ha demostrado una mezcla eficiente de líquidos viscosos a muy bajos números de Reynolds.
  • Se observó una inestabilidad elástica y un flujo irregular inducido por la adición de polímeros.
  • Los espectros de velocidad medidos son consistentes con las predicciones del régimen de Batchelor.
  • Se confirmaron las predicciones teóricas con respecto a las distribuciones de probabilidad de concentración (colas exponenciales) y las tasas de decaimiento (momentos exponenciales, correlación espacial logarítmica).

Conclusiones:

  • Los polímeros de alto peso molecular pueden inducir inestabilidades elásticas que promueven una mezcla eficiente en flujos simples a bajos números de Reynolds.
  • Las dinámicas de mezcla observadas se alinean con los modelos teóricos del régimen de Batchelor.
  • Esto proporciona un método eficaz y de baja concentración para mejorar la mezcla de fluidos en escenarios específicos.