Video Experimental Relacionado

Updated: Jul 12, 2026

The Preparation of Electrohydrodynamic Bridges from Polar Dielectric Liquids
10:03

The Preparation of Electrohydrodynamic Bridges from Polar Dielectric Liquids

Published on: September 30, 2014

Sprites, ELF Transientes y golpes positivos en el suelo.

D J Boccippio, E R Williams, S J Heckman

    Science (New York, N.Y.)
    |August 25, 1995
    PubMed
    Resumen

    Los sprites ópticos mesosféricos a menudo ocurrían con rayos positivos y resonancia de Schumann en sistemas convectivos de mesoscala. Esto sugiere que los sprites se activan por la rápida eliminación de la carga que estresa la mesosfera hasta la ruptura.

    Más Videos Relacionados

    Multifunctional Setup for Studying Human Motor Control Using Transcranial Magnetic Stimulation, Electromyography, Motion Capture, and Virtual Reality08:09

    Multifunctional Setup for Studying Human Motor Control Using Transcranial Magnetic Stimulation, Electromyography, Motion Capture, and Virtual Reality

    Published on: September 3, 2015

    A Simple Stimulatory Device for Evoking Point-like Tactile Stimuli: A Searchlight for LFP to Spike Transitions07:34

    A Simple Stimulatory Device for Evoking Point-like Tactile Stimuli: A Searchlight for LFP to Spike Transitions

    Published on: March 25, 2014

    Videos de Conceptos Relacionados

    Drift Velocity01:19

    Drift Velocity

    The high speed of electrical signals results from the fact that the force between charges acts rapidly at a distance. Thus, when a free charge is forced into a wire, the incoming charge pushes other charges ahead due to the repulsive force between like charges. These moving charges move the charges farther down the line. The density of charge in a system cannot easily be increased, so the signal is passed on rapidly. The resulting electrical shock wave moves through the system at nearly the...
    Series R—L Circuit Transients01:22

    Series R—L Circuit Transients

    In a series resistor-inductor (R-L) circuit, closing the switch at the start of the time period simulates a three-phase short circuit, a fault condition where all three phases of an unloaded synchronous machine are short-circuited. When there is no fault impedance and no initial current, the initial voltage is determined by the phase angle of the source voltage.
    Using Kirchhoff's Voltage Law (KVL) to analyze this circuit helps determine the total asymmetrical fault current, which consists of...
    Lossy Lines and Overvoltages01:22

    Lossy Lines and Overvoltages

    Transmission-line series resistance and shunt conductance cause three primary effects: attenuation, distortion, and power losses.
    Attenuation
    When constant series resistance and shunt conductance are present, voltage and current equations are modified. The propagation constant indicates that voltage and current waves consist of both forward and backward traveling components. These waves attenuate as they propagate, with the attenuation factor related to the resistance and conductance. In a...
    Van de Graaff Generator01:15

    Van de Graaff Generator

    Van de Graaff generators (or Van de Graaffs) are devices used to demonstrate high voltage due to static electricity that can also be used for research. Robert Van de Graaff first built one in 1931 (based on original suggestions by Lord Kelvin) for use in nuclear physics research.
    Van de Graaff uses both smooth and pointed surfaces, conductors, and insulators to generate large static charges and, hence, large voltages. A substantial excess charge can be deposited on the sphere because it moves...
    Electric Field Lines01:26

    Electric Field Lines

    The three-dimensional representation of the electric field of a positive point charge requires tracing the electric field vectors, whose lengths decrease as the square of their distance from the charge and which point away from the charge at each point. This vector field is no doubt challenging to visualize. The visualization of electric fields becomes quickly intractable as the number of charges increases.
    The solution to this problem is to use electric field lines, which are not vectors but...
    Back EMF01:24

    Back EMF

    Generators convert mechanical energy into electrical energy, whereas motors convert electrical energy into mechanical energy. A motor works by sending a current through a loop of wire located in a magnetic field. As a result, the magnetic field exerts a torque on the loop. This rotates a shaft, extracting mechanical work from the electrical current sent in initially. When the coil of a motor is turned, magnetic flux changes through the coil, and an emf (consistent with Faraday's law) is induced.