Video Experimental Relacionado

Updated: Jul 12, 2026

Simulating Impacts of Ice Storms on Forest Ecosystems
06:27

Simulating Impacts of Ice Storms on Forest Ecosystems

Published on: June 30, 2020

Los remolinos del borde del hielo en la zona de hielo marginal del estrecho de Fram

O M Johannessen, J A Johannessen, E Svendsen

    Science (New York, N.Y.)
    |April 24, 1987
    PubMed
    Resumen

    Se observaron remolinos prominentes del borde del hielo en el estrecho de Fram con velocidades de hasta 40 cm / s y vidas de más de 20 días. El derretimiento dentro de estos remolinos influye significativamente en la posición del borde del hielo, ofreciendo nuevos conocimientos sobre la dinámica de los remolinos.

    Más Videos Relacionados

    Ice Generation and the Heat and Mass Transfer Phenomena of Introducing Water to a Cold Bath of Brine08:16

    Ice Generation and the Heat and Mass Transfer Phenomena of Introducing Water to a Cold Bath of Brine

    Published on: March 13, 2017

    Laser-Induced Fluorescence Emission (L.I.F.E.) as Novel Non-Invasive Tool for In-Situ Measurements of Biomarkers in Cryospheric Habitats13:38

    Laser-Induced Fluorescence Emission (L.I.F.E.) as Novel Non-Invasive Tool for In-Situ Measurements of Biomarkers in Cryospheric Habitats

    Published on: October 26, 2019

    Videos de Conceptos Relacionados

    Frost Action on Concrete01:27

    Frost Action on Concrete

    Concrete structures in cold climates, such as those along roadsides, can retain moisture. This moisture makes them susceptible to frost-related damage when temperatures fall below freezing. Adding moisture worsens the damage during temperature fluctuations, leading to repeated freezing and thawing. De-icing salts, spread over these structures to melt ice, add to the freeze-thaw cycle, and draw even more moisture into the concrete.
    This freeze-thaw cycle primarily causes surface scaling, where...
    Phase Transitions: Melting and Freezing02:39

    Phase Transitions: Melting and Freezing

    Heating a crystalline solid increases the average energy of its atoms, molecules, or ions, and the solid gets hotter. At some point, the added energy becomes large enough to partially overcome the forces holding the molecules or ions of the solid in their fixed positions, and the solid begins the process of transitioning to the liquid state or melting. At this point, the temperature of the solid stops rising, despite the continual input of heat, and it remains constant until all of the solid is...
    Freezing Point Depression and Boiling Point Elevation03:12

    Freezing Point Depression and Boiling Point Elevation

    Boiling Point Elevation
    The boiling point of a liquid is the temperature at which its vapor pressure is equal to ambient atmospheric pressure. Since the vapor pressure of a solution is lowered due to the presence of nonvolatile solutes, it stands to reason that the solution’s boiling point will subsequently be increased. Vapor pressure increases with temperature, and so a solution will require a higher temperature than will pure solvent to achieve any given vapor pressure, including one...
    Freezing Point Depression and Boiling Point Elevation01:24

    Freezing Point Depression and Boiling Point Elevation

    When a non-volatile solute is added to a pure solvent, it results in the lowering of the freezing point of the solvent. This phenomenon is called freezing point depression. The extent to which the freezing point is lowered depends on the molality of the solute -the number of moles of solute per kilogram of solvent and the cryoscopic constant of the solvent.From the plot of chemical potential, μ, against temperature, it is evident that the μ of both solid and liquid solvents decrease with...
    Eddy Currents01:25

    Eddy Currents

    Since eddy currents occur only in conductors, magnets can separate metals from other materials. For example, in a recycling center, trash is dumped in batches down a ramp, beneath which lies a powerful magnet. Conductors in the trash are slowed by eddy currents, while nonmetals in the trash move on, separating from the metals. This works for all metals, not just ferromagnetic ones.
    Other major applications of eddy currents appear in metal detectors and the braking systems of trains and roller...
    Framing Effects03:26

    Framing Effects

    Information is everywhere and its presentation—such as how and when items are presented—can impact our perceptions and decisions surrounding the info. This broad concept umbrellas framing effects—influences that occur due to the way information is framed in its appearance, whether it’s purely the order or the specific wording of a message. Let’s take a look at numerous ways in which two versions of something can objectively say the same thing, yet we respond in different ways based on the...