Video Experimental Relacionado

Updated: Jul 11, 2026

Kinematic History of a Salient-recess Junction Explored through a Combined Approach of Field Data and Analog Sandbox Modeling
06:55

Kinematic History of a Salient-recess Junction Explored through a Combined Approach of Field Data and Analog Sandbox Modeling

Published on: August 5, 2016

Estructura fina de la zona de falla de los módulos de aterrizaje: segmentación y el proceso de ruptura

Y G Li, K Aki, J E Vidale

    Science (New York, N.Y.)
    |July 15, 1994
    PubMed
    Resumen

    Las ondas de corte sísmico revelan una zona de falla de 100 a 200 metros de ancho con velocidad reducida en el terremoto de Landers de 1992. Esta zona de falla actuó como una guía de ondas sísmica, influyendo en la dinámica de ruptura y sugiriendo planos de falla complejos.

    Más Videos Relacionados

    The Role of Fabric in Frictional Properties of Phyllosilicate-Rich Tectonic Faults07:39

    The Role of Fabric in Frictional Properties of Phyllosilicate-Rich Tectonic Faults

    Published on: November 6, 2021

    Visualization of Failure and the Associated Grain-Scale Mechanical Behavior of Granular Soils under Shear using Synchrotron X-Ray Micro-Tomography09:00

    Visualization of Failure and the Associated Grain-Scale Mechanical Behavior of Granular Soils under Shear using Synchrotron X-Ray Micro-Tomography

    Published on: September 29, 2019

    Videos de Conceptos Relacionados

    Fault Types01:18

    Fault Types

    When analyzing a single line-to-ground fault from phase A to ground at a three-phase bus, it is important to consider the fault impedance. This impedance is zero for a bolted fault, equal to the arc impedance for an arcing fault, and represents the total fault impedance for a transmission-line insulator flashover. To derive sequence and phase currents, fault conditions are translated from the phase domain to the sequence domain.
    For line-to-line faults occurring between phases B and C, the...
    Stress-Strain Diagram - Brittle Materials01:24

    Stress-Strain Diagram - Brittle Materials

    Brittle materials, including glass, cast iron, and stone, exhibit unique characteristics. They fracture without considerable change in their elongation rate, indicating that their breaking and ultimate strength are equivalent. Such materials also show lower strain levels at the point of rupture. The failure in brittle materials predominantly results from normal stresses, as evidenced by the rupture created along a surface perpendicular to the applied load. These materials do not display...
    Transition Zone01:28

    Transition Zone

    The transition zone in concrete is a critical area where aggregate meets cement paste, marked by a distinct porosity and weakness compared to the surrounding material. The adhesion around the aggregates is primarily due to Van Der Waals forces. The voids within this zone influence its robustness; initially, it is less durable than the surrounding bulk mortar due to larger voids. Initially, when concrete is compacted, a higher water-cement ratio near the aggregates leads to the formation of...
    Imperfections in Crystal Structure: Point, Line and Plane Defects01:25

    Imperfections in Crystal Structure: Point, Line and Plane Defects

    A perfect crystal, in theory, has a uniform structure with the same unit cell and lattice points throughout. However, any deviation from this periodic arrangement is known as an imperfection or defect. These defects can be categorized into three types: point, line, and plane defects.Point defects occur when there is a deviation from the ideal due to missing atoms, displaced atoms, or additional atoms. These imperfections might occur due to imperfect packing during crystallization or because of...