Videos de Conceptos Relacionados

Graded Potential01:19

Graded Potential

Graded potentials are localized fluctuations in the cell membrane's electrical charge, commonly found in the dendrites of neurons. The magnitude of these potential changes depends on the strength of the initiating stimulus. In a membrane at its resting potential, a graded potential signifies a voltage shift either above -70 mV or below -70 mV.
Graded potentials fall into two categories: depolarizing and hyperpolarizing. Depolarizing graded potentials typically occur when sodium (Na+) or calcium...
Gravimetry: Overview01:05

Gravimetry: Overview

Gravimetric analysis is a quantitative method where the analyte is isolated and weighed directly or after conversion into a substance of known composition. Gravimetric analysis can be classified as precipitation, electrogravimetry, volatilization, and particulate gravimetry, based on the method used to isolate the analyte.
In precipitation gravimetry, the analyte is converted into a precipitate and weighed. For example, the silver content in a sample can be estimated by precipitating and...
The Bell Curve01:21

The Bell Curve

The normal probability distribution, often depicted as a symmetrical, bell-shaped curve, is fundamental in statistics and the study of natural phenomena. This pattern, famously described by mathematician Carl Friedrich Gauss, shows how data points are distributed around a central mean, with most values near the average and fewer observations occurring as they deviate further from it.
This pattern applies to many human characteristics beyond intelligence, such as height. For example, if you...
Quantifying and Rejecting Outliers: The Grubbs Test01:02

Quantifying and Rejecting Outliers: The Grubbs Test

Sometimes, a data set can have a recorded numerical observation that greatly  deviates from the rest of the data. Assuming that the data is normally distributed, a statistical method called the Grubbs test can be used to determine whether the observation is truly an outlier.  To perform a two-tailed Grubbs test, first, calculate the absolute difference between the outlier and the mean. Then, calculate the ratio between this difference and the standard deviation of the sample. This number is...
Ogive Graph01:07

Ogive Graph

An ogive graph is sometimes called a cumulative frequency polygon. It is one type of frequency polygon that shows cumulative frequency. In other words, the cumulative percentages are added to the graph from left to right. An ogive graph plots cumulative frequency on the vertical y-axis and class boundaries along the horizontal x-axis. It’s very similar to a histogram; only instead of rectangles, an ogive displays a single point where the top right of the rectangle would be. Creating this type...
Wheatstone Bridge01:29

Wheatstone Bridge

An ohmmeter is a resistance-measuring device. It works by applying a voltage to a resistor of unknown resistance and measuring the current across the resistor. The resistance value is deduced using Ohm's law. Usually, the standard configuration of an ohmmeter comprises a voltmeter or an ammeter. However, such configurations are limited in accuracy because the meters alter the voltage applied to the resistor and the current that flows through it.
Thus, for accurate resistance measurements, a...