Video Experimental Relacionado

Updated: Feb 7, 2026

Versatile Technique to Produce a Hierarchical Design in Nanoporous Gold
05:28

Versatile Technique to Produce a Hierarchical Design in Nanoporous Gold

Published on: February 10, 2023

2.2K

Fe de erratas: Diferencias en los cambios estructurales jerárquicos entre P(3HB) no orientado y P(3HB-co-3HH) bajo

Masato Arakawa1, Taizo Kabe2, Tadahisa Iwata2

  • 1Institute for Chemical Research Kyoto University Gokasho Uji Kyoto611-0011 Japan.

Journal of applied crystallography
|February 6, 2026
PubMed
Resumen

Este estudio corrige un artículo publicado anteriormente con DOI. La corrección garantiza la cita y referencia precisas para la integridad científica.

Palabras clave:
P(3HB)P(3HB-co-3HH)USAXSpolímeros cristalinosdispersión de rayos X in situfluctuaciones de densidad inducidas por estiramientodispersión de rayos X de ultra ángulo pequeño

Más Videos Relacionados

Hierarchical and Programmable One-Pot Oligosaccharide Synthesis09:56

Hierarchical and Programmable One-Pot Oligosaccharide Synthesis

Published on: September 6, 2019

7.3K
Heuristic Mining of Hierarchical Genotypes and Accessory Genome Loci in Bacterial Populations08:03

Heuristic Mining of Hierarchical Genotypes and Accessory Genome Loci in Bacterial Populations

Published on: December 7, 2021

2.8K

Videos de Conceptos Relacionados

IR Frequency Region: X–H Stretching01:24

IR Frequency Region: X–H Stretching

In IR spectroscopy, signals produced by the X−H bonds (such as C−H, O−H, or N−H) can be observed in the frequency range of  2700–4000 cm–1. The C−H stretching vibration forms sharp bands in the region 2850–3000 cm–1. The presence of the O−H stretching vibration leads to the forming of an absorption band in the frequency range 3650–3200 cm−1. At the same time, N−H stretching can be confirmed by absorption bands in...
1.5K
Electric Potential and Potential Difference01:16

Electric Potential and Potential Difference

Suppose a positive test charge moves away from a positive static charge, then the Coulomb force does positive work, and its electric potential energy decreases. The potential energy per unit charge is defined as the electric potential. The electric potential is independent of the test charge.
When a test charge moves from the initial to the final position, the electric potential difference between those positions is defined as the ratio of the change in the potential energy to the charge on the...
5.7K
Difference from Background: Limit of Detection01:05

Difference from Background: Limit of Detection

The limit of detection (LOD) is the smallest amount of analyte that can be distinguished from the background noise. The LOD value corresponds to the concentration at which the analyte signal is three times larger than the standard deviation of the blank signal. Below this value, the analyte signal cannot be differentiated from the background noise. It is calculated by dividing the calibration slope by 3 times the standard deviation of the blank signals.
The LOD indicates the presence or absence...
8.4K
Identifying Statistically Significant Differences: The F-Test01:14

Identifying Statistically Significant Differences: The F-Test

The F-test is used to compare two sample variances to each other or compare the sample variance to the population variance. It is used to decide whether an indeterminate error can explain the difference in their values. The underlying assumptions that allow the use of the F-test include the data set or sets are normally distributed, and the data sets are independent of each other. The test statistic F is calculated by dividing one variance by another. In other words, the square of one standard...
3.8K
Sum and Difference OpAmps01:22

Sum and Difference OpAmps

Operational amplifiers (op-amps) are versatile devices that extend beyond amplification. In this context, two specific op-amp configurations are explored: the summing and difference amplifiers.
A summing amplifier, or an adder, utilizes an op-amp to merge multiple input signals into a single output signal. When audio signals are introduced into its input channels, the input resistors initiate currents that traverse feedback resistors, resulting in an output voltage. Applying Kirchhoff's current...
1.4K
IR Frequency Region: Alkyne and Nitrile Stretching01:22

IR Frequency Region: Alkyne and Nitrile Stretching

Both alkyne (C≡C) and nitrile (C≡N) functional groups contain triple bonds and show stretching absorptions around the wavenumber range of 2100 to 2300 cm−1 in the diagnostic region of the IR spectra.
Comparing the stretching vibrational frequency of  C≡C triple bonds with that of double and single bonds, it is evident that C≡C triple bonds exhibit a higher stretching frequency than C=C double and C–C single bonds. Similarly, the C≡N triple bond...
1.5K