Video Experimental Relacionado
Updated: May 3, 2026
A Coupled Experiment-finite Element Modeling Methodology for Assessing High Strain Rate Mechanical Response of Soft Biomaterials
Published on: May 18, 2015
Evaluación biomecánica de arquitecturas de vástago humeral sólido y poroso múltiple en artroplastia de hombro inversa
Pearline Beulah John1, Sharmila Nageswaran1
1Department of Sensor and Biomedical Technology, School of Electronics Engineering, Vellore Institute of Technology, Vellore, India.
Introduction:
Stress shielding is a major cause of radiological changes in the humeral component, which is commonly evident in cementless stems of reverse shoulder implants. The bulkiness of the humeral stem results in less load being transmitted to the bone, curtailing bone remodeling. Designing an implant with adequate strength and a suitable material that matches the mechanical properties of bone can help prevent the implant migration or loosening, thereby lowering bone resorption.
Methods:
Humeral stems with no porosity and varied porosities, such as circular, elliptical, and trabecular architecture, were designed using 316L stainless steel and titanium alloy (Ti6Al4V). Finite element analysis (FEA) was conducted on eight bone-implant assemblies under four loading conditions for cortical and trabecular bones. Weighted mean of von Mises stress and mechanobiology associated with the strain energy densities were studied. This serves as a precursor in predicting the effect of stress shielding.
Results:
The titanium implant with trabecular architecture was mechanically close to the intact bone compared to the other varied porosity designs. It also had better load-bearing capacity than the solid stems.
Discussion:
These investigations help understand the load-bearing capacity of reverse shoulder humeral stems and ascertain the importance of combining the design and material in enhancing implant stability and longevity.
