関連する実験動画

Updated: Jul 16, 2026

Experimental Methods for Trapping Ions Using Microfabricated Surface Ion Traps
11:45

Experimental Methods for Trapping Ions Using Microfabricated Surface Ion Traps

Published on: August 17, 2017

リバースミセルの興奮状態の陽子移転

Boiko Cohen1, Dan Huppert, Kyril M Solntsev

  • 1Raymond and Beverly Sackler Faculty of Exact Sciences, School of Chemistry, Tel Aviv University, Ramat Aviv 69978, Israel.

Journal of the American Chemical Society
|June 20, 2002
PubMed
まとめ

水/AOTの反転したミセルのプロトン拡散は,ミセラ構造の洞察を明らかにします. この研究では,ミセラ水相の介電定数がミセラサイズによって変化し,水の性質に影響することを発見しました.

さらに関連する動画

In Situ Transmission Electron Microscopy with Biasing and Fabrication of Asymmetric Crossbars Based on Mixed-Phased a-VOx09:49

In Situ Transmission Electron Microscopy with Biasing and Fabrication of Asymmetric Crossbars Based on Mixed-Phased a-VOx

Published on: May 13, 2020

High-Speed Magnetic Tweezers for Nanomechanical Measurements on Force-Sensitive Elements08:50

High-Speed Magnetic Tweezers for Nanomechanical Measurements on Force-Sensitive Elements

Published on: May 12, 2023

関連する概念動画

Cell Migration01:09

Cell Migration

Cell migration, the process by which cells move from one location to another, is essential for the proper development and viability of organisms throughout their life. When cells are not able to migrate properly to their ordained locations, various disorders may occur. For example, disruption in cell migration causes chronic inflammatory diseases such as arthritis.
Phase Transitions: Melting and Freezing02:39

Phase Transitions: Melting and Freezing

Heating a crystalline solid increases the average energy of its atoms, molecules, or ions, and the solid gets hotter. At some point, the added energy becomes large enough to partially overcome the forces holding the molecules or ions of the solid in their fixed positions, and the solid begins the process of transitioning to the liquid state or melting. At this point, the temperature of the solid stops rising, despite the continual input of heat, and it remains constant until all of the solid is...
Thermal Sigmatropic Reactions: Overview01:16

Thermal Sigmatropic Reactions: Overview

Sigmatropic rearrangements are a class of pericyclic reactions in which a σ bond migrates from one part of a π system to another. These are intramolecular rearrangements where the total number of σ and π bonds remain unchanged.
Sigmatropic shifts are classified based on an order term [i, j ], where i and j indicate the number of atoms across which each end of the σ bond migrates. Below are examples of a [3,3] sigmatropic shift in 1,5-hexadiene, referred to as...
Atomic Nuclei: Magnetic Resonance01:05

Atomic Nuclei: Magnetic Resonance

The number of nuclear spins aligned in the lower energy state is slightly greater than those in the higher energy state. In the presence of an external magnetic field, as the spins precess at the Larmor frequency, the excess population results in a net magnetization oriented along the z axis. When a pulse or a short burst of radio waves at the Larmor frequency is applied along the x axis, the coupling of frequencies causes resonance and flips the nuclear spins of the excess population from the...
Atomic Nuclei: Nuclear Relaxation Processes01:23

Atomic Nuclei: Nuclear Relaxation Processes

In the absence of an external magnetic field, nuclear spin states are degenerate and randomly oriented. When a magnetic field is applied, the spins begin to precess and orient themselves along (lower energy) or against (higher energy) the direction of the field. At equilibrium, a slight excess population of spins exists in the lower energy state. Because the direction of the magnetic field is fixed as the z-axis,  the precessing magnetic moments are randomly oriented around the z-axis. This...
Carrier Generation and Recombination01:22

Carrier Generation and Recombination

Carrier generation is the process by which electron-hole pairs (EHPs) are created within the semiconductor. In direct-bandgap semiconductors, such as gallium arsenide (GaAs), this occurs efficiently when energy absorption prompts valence electrons to leap into the conduction band, leaving behind holes.
This process is given by the generation rate G and is efficient due to the conservation of momentum between the valence band maximum and conduction band minimum.
Indirect generation involves an...