Different notations are used to represent the three-dimensional structure of molecules on two-dimensional surfaces. One of the most commonly used representations is the dash-wedge formula. The dashed wedges, solid wedges, and the plane lines indicate the groups situated behind the plane, coming out of the plane, and in the plane, respectively.
The organic molecules rotate across the single bonds leading to numerous temporary three-dimensional structures of varying energy known as conformers.

One of the distinctive characteristics of circular shafts is their ability to maintain their cross-sectional integrity under torsion. In other words, each cross-section continues to exist as a flat, unaltered entity, simply rotating like a solid, rigid slab. To understand the distribution of shearing stress within such a shaft, consider a cylindrical section inside this circular shaft. This section has a length of L and a radius of R, with one end fixed. The radius of the cylindrical section is...

Circular shafts undergoing torsional stress maintain their cross-sectional integrity due to their axisymmetric nature. This symmetry ensures an even distribution of stress, allowing the shaft to withstand torsion without distorting. In contrast, square bars, lacking this axial symmetry, experience significant distortion across their cross-sections when subjected to torsion, with the exception of along their diagonals and at lines connecting midpoints. A detailed examination of a cubic element...

When analyzing the deformation of a symmetric prismatic member subjected to bending by equal and opposite couples, it becomes clear that as the member bends, the originally straight lines on its wider faces curve into circular arcs, with a constant radius centered at a point known as Point C. This phenomenon helps to understand the stress and strain distribution within the member more clearly.
When the member is segmented into tiny cubic elements, it is observed that the primary stress...

Unsymmetrical bending occurs when a structural member is subjected to bending moments in a plane that does not align with the member's principal axes. This scenario typically arises in beams and other structural components when loads are applied at non-ideal angles, introducing complexities in stress analysis.
When a bending moment is applied at an angle θ concerning the vertical axis of a symmetrical member, it can be resolved into components along the member's principal centroidal axes. The...

A surface is called orientable if a consistent choice of unit normal vector can be made at every point on the surface. A thin soap film stretched across a wire loop provides a familiar example. The film separates the air on one side from the air on the other, so one side can be selected as positive and the opposite side as negative. Once this choice is made, a unit normal vector can be assigned smoothly across the entire surface.At each point on the soap film, a unit normal vector points...