関連する実験動画

Updated: Jun 16, 2026

Measurement of Coherence Decay in GaMnAs Using Femtosecond Four-wave Mixing
15:58

Measurement of Coherence Decay in GaMnAs Using Femtosecond Four-wave Mixing

Published on: December 3, 2013

断片化によるスペクトル拡大と副産物の生成は,エアイパルス駆動型ブロードバンドのカスケード式4波混合で発生する

Lucien Mandeng Mandeng, Clément Tchawoua

    Optics express
    |February 20, 2026
    PubMed
    まとめ

    断片化されたエアリーパルス (TAP) は,カスケード4波混合 (CFWM) で調節可能なスペクトル拡大を可能にします. 切断係数はエネルギー局所化と相非対称性を制御し,ブロードバンド光発電のためのCFWM効率を最適化します.

    さらに関連する動画

    Infrared Degenerate Four-wave Mixing with Upconversion Detection for Quantitative Gas Sensing10:42

    Infrared Degenerate Four-wave Mixing with Upconversion Detection for Quantitative Gas Sensing

    Published on: March 22, 2019

    Multiplex Chemical Imaging Based on Broadband Stimulated Raman Scattering Microscopy09:57

    Multiplex Chemical Imaging Based on Broadband Stimulated Raman Scattering Microscopy

    Published on: July 25, 2022

    関連する概念動画

    IR Spectrum Peak Broadening: Hydrogen Bonding01:23

    IR Spectrum Peak Broadening: Hydrogen Bonding

    The vibrational frequency of a bond is directly proportional to its bond strength. As a result, stronger bonds vibrate at higher frequencies, while weaker bonds vibrate at lower frequencies. The stretching vibration of the strong O–H bond in alcohols and phenols (very dilute solution or gas phase) appears as a sharp peak at 3600–3650 cm−1.
    However, the extent of hydrogen bonding influences the observed stretching frequency and band broadening. Intermolecular or intramolecular hydrogen bonding...
    IR Spectrum Peak Splitting: Symmetric vs Asymmetric Vibrations01:08

    IR Spectrum Peak Splitting: Symmetric vs Asymmetric Vibrations

    Identical bonds within a polyatomic group can stretch symmetrically (in-phase) or asymmetrically (out-of-phase). Similar to hydrogen bonding, these vibrations also influence the shape of the IR peak. Generally, asymmetric stretching frequencies are higher than symmetric stretching frequencies. For example, primary amines exhibit two distinct IR peaks between 3300–3500 cm−1 corresponding to the symmetric and asymmetric N-H stretching, while secondary amines exhibit a single stretching vibration...
    ¹³C NMR: ¹H–¹³C Decoupling01:04

    ¹³C NMR: ¹H–¹³C Decoupling

    The probability of having two carbon-13 atoms next to each other is negligible because of the low natural abundance of carbon-13. Consequently, peak splitting due to carbon-carbon spin-spin coupling is not observed in spectra. However, protons up to three sigma bonds away split the carbon signal according to the n+1 rule, resulting in complicated spectra.
    A broadband decoupling technique is used to simplify these complex, sometimes overlapping, signals. Broadband decoupling relies on a...
    Double Resonance Techniques: Overview01:12

    Double Resonance Techniques: Overview

    Double resonance techniques in Nuclear Magnetic Resonance (NMR) spectroscopy involve the simultaneous application of two different frequencies or radiofrequency pulses to manipulate and observe two distinct nuclear spins. One important application of double resonance is spin decoupling, which selectively suppresses coupling with one type of nucleus while observing the NMR signal from another nucleus, simplifying the spectrum and enhancing resolution.
    Spin decoupling is usually achieved by...
    Carrier Generation and Recombination01:22

    Carrier Generation and Recombination

    Carrier generation is the process by which electron-hole pairs (EHPs) are created within the semiconductor. In direct-bandgap semiconductors, such as gallium arsenide (GaAs), this occurs efficiently when energy absorption prompts valence electrons to leap into the conduction band, leaving behind holes.
    This process is given by the generation rate G and is efficient due to the conservation of momentum between the valence band maximum and conduction band minimum.
    Indirect generation involves an...
    Bandpass Sampling01:17

    Bandpass Sampling

    In signal processing, bandpass sampling is an effective technique for sampling signals that have most of their energy concentrated within a narrow frequency band. This type of signal is known as a bandpass signal. The key principle of bandpass sampling involves sampling the signal at a rate that is greater than twice the signal's bandwidth to prevent aliasing.
    A bandpass signal has a spectrum with a lower frequency limit, denoted as ω1, and an upper frequency limit, denoted as ω2. The spectrum...