In the late 19th-century, the number of new chemical compounds discovered increased tremendously. Hence, the necessity arose to develop a naming system for the systematic nomenclature of these newly discovered compounds. IUPAC (International Union for Pure and Applied Chemistry), established in 1919, sets rules for the nomenclature.
The alkane nomenclature considers the length of the carbon chain, the number, and the location of the substituent to arrive at its systematic name. The IUPAC...

The naming of enantiomers employs the Cahn–Ingold–Prelog rules that involve assigning priorities to different substituent groups at a chiral center. Each enantiomer, being a distinct molecule, is assigned a unique name by the Cahn–Ingold–Prelog (CIP) rules, also called the R–S system. The prefix R- or S- attached to the chiral centers in an enantiomer is dependent on the spatial arrangement of the four substituents on the chiral center. The R–S system essentially comprises three steps:...

Naming Amides
The IUPAC and common names of amides are derived from the parent carboxylic acid, by replacing the suffix “oic acid” and “ic acid,” respectively, with “amide.” In the following example, the IUPAC name ethanamide is derived from ethanoic acid, and the common name, acetamide, is obtained from acetic acid.

The simplest aromatic amine is phenylamine, which contains an –NH2 functionality directly attached to an aromatic ring. The name aniline is designated for this skeleton. As shown in Figure 1, the common names of the functionalized anilines involve prefixes ortho-, meta-, and para- to indicate the substitution position. Different functionalized aniline derivatives also have notable trivial names.

The International System of Units, known as the SI system, is a universally accepted measurement system recognized and used worldwide. The SI system is based on a set of three base units considered absolute, and their values do not change with location. These base units are meters, kilograms, and seconds.
Prefixes are used to define both larger and smaller quantities in the SI system. For example, milli, micro, and nano define smaller quantities, while kilo, mega, and giga are used to define...

During the development of a new pharmaceutical, the manufacturer initially assigns a code name to the drug. Once approved, the drug receives a United States Adopted Name (USAN)—a generic, nonproprietary designation. Upon being listed in the United States Pharmacopeia, this nonproprietary name becomes the drug's official name. Additionally, the manufacturer assigns a proprietary name or trademark, which serves as the brand name under which the drug is marketed. It is worth noting that the same...