美国国家卫生研究院预算. 在压力下进行同行评审.

Organisms must balance energy intake with the energy required for growth, maintenance, and reproduction. These trade-offs result in a variety of survivorship and reproductive strategies, including semelparity and iteroparity. Semelparous species reproduce only once in their lifetime, often investing most available resources into that single reproductive event. Iteroparous species, by contrast, reproduce multiple times over their lifetimes, typically allocating fewer resources to any single...

Stress concentration is when stress intensifies near discontinuities such as holes or abrupt cross-sectional changes in a structural member. This localized stress can often surpass the average stress within the member. The stress distribution in flat bars, either with a circular hole or varying widths connected by fillets, can be determined experimentally using a photoelastic method. The results are based on ratios of geometric parameters like the ratio of the hole's radius to the smaller width...

The concept of stress concentration is crucial for understanding how materials respond under bending stresses, particularly when there are irregularities or discontinuities in the material's geometry. Normally, stress in a symmetric member subjected to pure bending is assumed to be uniformly distributed across the entire cross-section. However, this assumption does not hold when there are variations in the cross-sectional geometry or the presence of notches and holes.
The stress concentration...

The general state of stress within a material can be accurately depicted using a stress tensor. This tensor encapsulates the internal forces distributed within a material subjected to external forces or deformations.
Specifically, consider a tetrahedral element where one face, labeled XYZ, is perpendicular to the line OA, and the remaining faces align with the coordinate axes with point O as the origin. At any point, such as point O, the stress tensor can be used to determine the stress...

When a force is applied on a body, it undergoes deformation. In order to restore the body to its original shape and/or size, an opposite or restoring force is generated within the body. This restoring force is equal to the magnitude of the applied force, but acts in the opposite direction. The amount of this restoring force developed per unit area of the body is called stress. Stress is a tensor quantity and has the SI unit pascal. Stress can be separated into four broad categories depending...

Consider a structure made of a boom and a rod designed to support a load. These two components are connected by a pin and stabilized by brackets and pins. The boom and the rod are detached from their supports to assess the different stresses imposed on this structure, and a free-body diagram is drawn. Then, all the forces applied, including the load acting on the structure, are identified. The reaction forces exerted on both the boom and the rod are computed using the equilibrium equations.
The...