探索HONO形成及其在北中国平原冬季推动二次污染物形成中的作用

Enthalpy changes are typically tabulated for reactions in which both the reactants and products are at the same conditions. A standard state is a commonly accepted set of conditions used as a reference point for the determination of properties under other different conditions. For chemists, the IUPAC standard state refers to materials under a pressure of 1 bar and solutions at 1 M and does not specify a temperature. Many thermochemical tables list values with a standard state of 1 atm. Because...

Cyanohydrins are compounds that contain –CN and –OH groups on the same carbon atom. They are formed by the nucleophilic addition of the cyanide ions to the carbonyl group. Cyanide ions are highly basic and nucleophilic and can be generated from HCN under aqueous conditions. However, since HCN is a weak acid, the number of cyanide ions generated is very small. Hence, a small amount of base or KCN/NaCN is added to HCN to increase the concentration of the cyanide ions in the reaction...

Cyanohydrins are formed when cyanide nucleophiles and carbonyl compounds like aldehydes and ketones react. A strong base, the cyanide ion, catalyzes cyanohydrin formation. The ions are generated from HCN under aqueous conditions. Once the cyanide ions are generated, the first step involves the nucleophilic attack of the cyanide ions on the electrophilic carbonyl carbon. This attack shifts the π electrons from the C=O to the oxygen atom forming the alkoxide ion intermediate. The alkoxide anion...

After filtration, the precipitate is washed to remove coprecipitated impurities and any remaining mother liquor. Colloidal precipitates, such as silver chloride, are washed with an electrolyte (such as dilute nitric acid) to prevent the peptization of the precipitate. In the case of slightly soluble precipitates, the wash solution contains a common ion to reduce solubility. Lead sulfate, which is slightly soluble in water, is washed with dilute sulfuric acid. Similarly, wash solutions may be...

The experimental conditions in a gravimetric analysis should be optimized to maximize the particle size and purity of the obtained precipitate. Ideally, the concentration of the precipitating reagent should be low with effective stirring to maintain low relative supersaturation for the growth of large crystals. In homogeneous precipitation, the precipitant is slowly generated by a chemical reaction in the solution to avoid local reagent excesses. For example, urea decomposes gradually to...

As depicted in the figure below, the unsymmetrical ketones can form two possible enolates:  less substituted or more substituted enolates. Usually, the thermodynamic enolates are formed from the more substituted α-carbon atom, while the kinetic enolates are formed faster by deprotonation from the less substituted position. The thermodynamic enolates have lower energy, so they are  more stable. But the energy required to form kinetic enolates is less.