相关实验视频

Updated: Jul 25, 2025

Additive Manufacturing of Functionally Graded Ceramic Materials by Stereolithography
06:53

Additive Manufacturing of Functionally Graded Ceramic Materials by Stereolithography

Published on: January 25, 2019

14.4K

在增材制造中,用功能分级的外格子作为填充物的应用

Slawomir Kedziora1, Thierry Decker1, Elvin Museyibov1

  • 1Faculty of Science, Technology and Medicine, University of Luxembourg, 6 rue Coudenhove-Kalergi, L-1359 Luxembourg, Luxembourg.

Materials (Basel, Switzerland)
|June 28, 2023
PubMed
概括

这项研究表明,功能分级的格子填充器如何可以创建轻量级,增材制造的自行车旋臂. 这种创新设计显著改善了刚度与质量比,展示了可持续工程的潜力.

关键词:
添加剂制造 添加剂制造 添加剂制造骑自行车的拐臂是自行车的拐臂.设计探索 设计探索有限元素方法的有限元素方法.具有功能分级的格子结构结构.在充填中加注.

更多相关视频

Indirect Fabrication of Lattice Metals with Thin Sections Using Centrifugal Casting08:32

Indirect Fabrication of Lattice Metals with Thin Sections Using Centrifugal Casting

Published on: May 14, 2016

12.6K
A Facile and Eco-friendly Route to Fabricate PolyLactic Acid Scaffolds with Graded Pore Size13:46

A Facile and Eco-friendly Route to Fabricate PolyLactic Acid Scaffolds with Graded Pore Size

Published on: October 17, 2016

8.7K

相关概念视频

Thin-Walled Hollow Shafts01:15

Thin-Walled Hollow Shafts

In analyzing a thin-walled hollow shaft subjected to torsional loading, a segment with width dx is isolated for examination. Despite its equilibrium state, this segment faces torsional shearing forces at its ends. These forces are quantitatively described by the product of the longitudinal shearing stress on the segment's minor surface and the area of this surface, leading to the concept of shear flow. This shear flow is consistent throughout the structure, indicating a uniform distribution...
216
Design Example: Aggregate Gradation01:24

Design Example: Aggregate Gradation

The right type and quality of aggregates are crucial for concrete as they significantly influence its properties, mix proportions, and cost-effectiveness. If different sources are available for sand, the commonly used fine aggregate in concrete, the selection of sand is primarily based on its gradation.
The grading, or particle-size distribution, of sand is determined using sieve analysis, with standard sizes ranging from 150 μm to 10 mm (ASTM No. 100 sieve to 3⁄8 in. sieve). Sand is...
125