[新的,更昂贵的 - 不一定是更好的]

A complete procedure to test a claim about population standard deviation or population variance is explained here.
The hypothesis testing for the claim of population standard deviation (or variance) requires the data and samples to be random and unbiased. The population distribution also must be normal. There is no specific requirement on the sample size as the estimation is based on the chi-square distribution.
As a first step, the hypothesis (null and alternative) concerning the claim about...

In order to make good decisions, we use our knowledge and our reasoning. Often, this knowledge and reasoning is sound and solid. However, sometimes, we are swayed by biases or by others manipulating a situation. For example, let’s say you and three friends wanted to rent a house and had a combined target budget of $1,600. The realtor shows you only very run-down houses for $1,600 and then shows you a very nice house for $2,000. Might you ask each person to pay more in rent to get the...

The way a set of data is measured is called its level of measurement. Correct statistical procedures depend on a researcher being familiar with levels of measurement. For analysis, data are classified into four levels of measurement—nominal, ordinal, interval, and ratio.
A set of data measured using the ratio scale takes care of the ratio problem and provides complete information. Ratio scale data are like interval scale data, except they have a zero point and ratios can be calculated....

Pharmaceutical equivalents, by definition, are drug products with the same active ingredient in the same quantities, encapsulated in identical dosage forms, and intended for the same administration routes. These pharmaceutical equivalents are deemed bioequivalent if the bioavailability of the active entity in the drug preparations is similar. Moreover, pharmaceutical equivalents demonstrating bioequivalence are also regarded as therapeutically equivalent. This means that when used as directed,...

The limit of detection (LOD) is the smallest amount of analyte that can be distinguished from the background noise. The LOD value corresponds to the concentration at which the analyte signal is three times larger than the standard deviation of the blank signal. Below this value, the analyte signal cannot be differentiated from the background noise. It is calculated by dividing the calibration slope by 3 times the standard deviation of the blank signals.
The LOD indicates the presence or absence...

During the development of a new pharmaceutical, the manufacturer initially assigns a code name to the drug. Once approved, the drug receives a United States Adopted Name (USAN)—a generic, nonproprietary designation. Upon being listed in the United States Pharmacopeia, this nonproprietary name becomes the drug's official name. Additionally, the manufacturer assigns a proprietary name or trademark, which serves as the brand name under which the drug is marketed. It is worth noting that...