在聚合物溶液滴空气系统中的水,乙醇,拉姆诺脂和Triton X-165混合物的湿化行为
Anna Zdziennicka1, Edyta Rekiel1, Katarzyna Szymczyk1
1Department of Interfacial Phenomena, Institute of Chemical Sciences, Faculty of Chemistry, Maria Curie-Skłodowska University in Lublin, Maria Curie-Skłodowska Sq. 3, 20-031 Lublin, Poland.
Molecules (Basel, Switzerland)
|August 12, 2023
概括
通过使用水+乙醇溶液与脂 (RL) 和Triton X-165 (TX165) 溶液,研究了聚四乙烯 (PTFE) 和聚 (甲基甲酸) (PMMA) 的加湿性. 该研究揭示了表面活性剂混合物如何影响湿透性,为实际应用提供了洞察力.
科学领域:
- 表面科学是一门学科.
- 物理化学 物理化学
- 材料科学 材料科学 材料科学
背景情况:
- 多元组分混合物的湿性质对于许多应用至关重要,但尚未完全理解.
- 表面活性化合物显著影响液体混合物的行为.
研究的目的:
- 通过含有脂 (RL) 和Triton X-165 (TX165) 的水+乙醇溶液,研究聚四乙烯 (PTFE) 和聚 (甲基甲酸) (PMMA) 的浸湿性.
- 分析这些复杂混合物的热力学行为和界面层组成.
主要方法:
- 在PTFE和PMMA表面上进行前置接触角度测量.
- 在恒定的乙醇 (ET) 和脂 (RL) 度下,Triton X-165 (TX165) 度的系统变化.
- 热力学分析以确定各种接口上的混合物成分.
主要成果:
- 这项研究确定了TX165度对PTFE和PMMA浸泡性的影响.
- 热力学分析为界面混合层的形成提供了洞察力.
- 发现TX165+RL层可以在特定的接口 (固体溶液和溶液空气) 形成,这取决于ET度.
结论:
- 接口层的组成和度对于理解湿现象至关重要.
- 特定表面活性剂层 (TX165 + RL) 的形成取决于乙醇度.
- 结果与在溶液-空气和固体-溶液接口的吉布斯标准吸附自由能量一致.
相关概念视频
Aldehydes and Ketones with Water: Hydrate Formation
An oxygen-based nucleophile, like water, can undergo addition reactions with aldehydes and ketones. The reaction leads to the formation of hydrates, also referred to as 1,1-diols or geminal diols.
The formation of hydrates is a reversible reaction. Hydrate formation is influenced by steric and electronic factors accompanying the alkyl substituents on the carbonyl group: The rate of hydrate formation increases with a decrease in the number of alkyl groups attached to the carbonyl carbon. Hence,...
The formation of hydrates is a reversible reaction. Hydrate formation is influenced by steric and electronic factors accompanying the alkyl substituents on the carbonyl group: The rate of hydrate formation increases with a decrease in the number of alkyl groups attached to the carbonyl carbon. Hence,...
Colloidal precipitates
The high insolubility of some precipitates can result in an unfavorable relative supersaturation. This can lead to colloidal particles with a large surface-to-mass ratio, where adsorption is promoted. For instance, in the precipitation of silver chloride, silver ions are adsorbed on the surface of the colloidal particles, forming a primary layer. This layer attracts ions of opposite charge (such as nitrate ions), forming a diffuse secondary layer of adsorbed ions. This electric double layer...
Washing, Drying, and Ignition of Precipitates
After filtration, the precipitate is washed to remove coprecipitated impurities and any remaining mother liquor. Colloidal precipitates, such as silver chloride, are washed with an electrolyte (such as dilute nitric acid) to prevent the peptization of the precipitate. In the case of slightly soluble precipitates, the wash solution contains a common ion to reduce solubility. Lead sulfate, which is slightly soluble in water, is washed with dilute sulfuric acid. Similarly, wash solutions may be...
Phase Diagrams of Ternary Systems
Consider a ternary system, which is composed of three components: water (W), ethanoic acid (E), and trichloromethane (T). Here, Ethanoic acid (E) is fully miscible with both water (W) and trichloromethane (T), meaning it can mix entirely with either of them. However, water and trichloromethane have partial miscibility, meaning they can only mix to a certain extent, beyond which two separate phases will form.The phase diagram of a ternary system is represented as an equilateral triangle, where...
The Colloidal State
The formation of a colloidal system is exemplified by an aqueous solution containing Cl− ions is introduced to another containing Ag+ ions, resulting in the precipitation of solid AgCl as extremely tiny crystals. Instead of settling out as a filterable precipitate, these crystals remain suspended in the liquid, showcasing a colloidal system.A colloidal system involves colloidal particles within the approximate range of 1 to 1000 nm in at least one dimension, dispersed in a medium called the...
Air-entraining Agents
Air-entraining agents improve the durability and workability of concrete in climates with frequent freezing and thawing. These agents prevent cracks by introducing small air bubbles into the mix, creating spaces accommodating water expansion when temperatures drop. The air-entraining agents lower the surface tension of water, forming stable, small air bubbles. This method is more effective than having accidental large voids, as the intentional, smaller, and evenly distributed air voids improve...


