时间轴:灵活和特异性的时间轴的草图式创作

A time-series graph is a line graph with repeated measurements taken at successive intervals of time. It is also called a time series chart. To construct a time-series graph, one must look at both pieces of a paired data set. The horizontal axis is used to plot the time increments, and the vertical axis is used to plot the values of the variable that one is measuring. By using the axes in this way, each point on the graph will correspond to time and a measured quantity. The points on the graph...

Analyzing two sinusoidal voltages with equal amplitude and period but different phases on an oscilloscope, an instrument used to display and analyze waveforms, involves a three-step process.
The first step is measuring the peak-to-peak value, which is twice the amplitude of the sinusoid. This provides information about the maximum voltage swing of the waveform.
Secondly, the period and angular frequency are determined. The period is the time taken for one complete cycle of the waveform, while...

The pV diagram, which is a graph of pressure versus volume of the gas under study, is helpful in describing certain aspects of the substance. When the substance behaves like an ideal gas, the ideal gas equation describes the relationship between its pressure and volume. On a pV diagram, it is common to plot an isotherm, which is a curve showing p as a function of V with the number of molecules and the temperature fixed. Then, for an ideal gas, the product of the pressure of the gas and its...

Bode plots are graphical tools that use logarithmic scales for frequency on the x-axis and gain in decibels on the y-axis. This logarithmic method allows a wide range of frequencies to be compactly displayed, enabling the analysis of component effects on circuit behavior across a broad frequency spectrum.
A network function represents the ratio of a system's output to its input, with the magnitude and phase angle derived from the complex network function. The decibel logarithmic gain is...

A system is linear if it displays the characteristics of homogeneity and additivity, together termed the superposition property. This principle is fundamental in all linear systems. Linear time-invariant (LTI) systems include systems with linear elements and constant parameters.
The input-output behavior of an LTI system can be fully defined by its response to an impulsive excitation at its input. Once this impulse response is known, the system's reaction to any other input can be...

The most common and easiest way to display the relationship between two variables, x and y, is a scatter plot. A scatter plot shows the direction of a relationship between the variables. A clear direction happens when there is either: