垃圾填埋场液预处理的过程使用凝结和水力动态化氧化
Yina Qiao1, Riya Jin1, Jingshuai Gao1
1School of Environment and Safety Engineering, North University of China Shanxi Taiyuan 030051 P. R. China qiaoyina@nuc.edu.cn.
RSC advances
|November 6, 2023
概括
这项研究引入了一种新型的凝固和水力动力腔化/二氧化 (HC/ClO2) 过程,用于有效地处理垃圾填埋场的液. 结合方法实现了83.58%的化学氧需求 (COD) 消除,显著降低了有机负载.
科学领域:
- 环境科学 环境科学
- 水处理工程水处理工程
- 化学工程是化学工程的重要组成部分.
背景情况:
- 垃圾填埋场液由于其复杂和具有挑战性的成分,存在重大环境和健康风险.
- 有效地处理垃圾填埋场的液对于减轻污染至关重要.
- 物理化学组合方法由于其有效性和成本效益,为水处理提供了有前途的方法.
研究的目的:
- 提出和评估一种新的垃圾填埋污水组合处理方法.
- 调查凝血和水力动力腔化/二氧化 (HC/ClO2) 处理的最佳条件.
- 评估联合工艺在减少化学氧气需求 (COD) 的效率.
主要方法:
- 对凝血参数的实验研究.
- 对水力动态化/二氧化 (HC/ClO2) 处理参数进行实验性调查.
- 评估用于垃圾填埋污水处理的联合凝结和HC/ClO2工艺.
主要成果:
- 通过最佳凝血,可达到60.14%的COD去除率.
- 最佳的HC/ClO2处理实现了58.82%的COD去除率.
- 结合凝固和HC/ClO2的过程显示了显著的83.58%的COD去除率.
结论:
- 拟议的联合凝结和HC/ClO2方法在垃圾填埋污水处理方面非常有效.
- 这一过程大大降低了有机物负载,使随后的生物处理更有效和更具成本效益.
- 这些发现支持这种综合方法的应用,以实现对垃圾填埋场污水的可持续管理.
更多相关视频
15:19Development of Sulfidogenic Sludge from Marine Sediments and Trichloroethylene Reduction in an Upflow Anaerobic Sludge Blanket Reactor
Published on: October 15, 2015
9.7K
07:34Evaluation of Integrated Anaerobic Digestion and Hydrothermal Carbonization for Bioenergy Production
Published on: June 15, 2014
25.6K
相关概念视频
Coagulation
308
Colloidal solids are solid particles suspended in solution. They are usually negatively charged, attracting a compact primary layer of positively charged ions, which attract more counterions to form an electrical double layer. Electrostatic repulsion between the charged double layers prevents the particles from colliding, stabilizing the colloids. These solids are often undesirable because they can contain toxins that are difficult to remove. Coagulation is a technique that helps aggregate and...
308
Bioremediation
18.6K
Bioremediation is the use of prokaryotes, fungi, or plants to remove pollutants from the environment. This process has been used to remove harmful toxins in groundwater as a byproduct of agricultural run-off and also to clean up oil spills.
18.6K
Factors Affecting Solubility
33.5K
Compared with pure water, the solubility of an ionic compound is less in aqueous solutions containing a common ion (one also produced by dissolution of the ionic compound). This is an example of a phenomenon known as the common ion effect, which is a consequence of the law of mass action that may be explained using Le Chȃtelier’s principle. Consider the dissolution of silver iodide:
33.5K
Colloidal precipitates
594
The high insolubility of some precipitates can result in an unfavorable relative supersaturation. This can lead to colloidal particles with a large surface-to-mass ratio, where adsorption is promoted. For instance, in the precipitation of silver chloride, silver ions are adsorbed on the surface of the colloidal particles, forming a primary layer. This layer attracts ions of opposite charge (such as nitrate ions), forming a diffuse secondary layer of adsorbed ions. This electric double layer...
594
Extraction: Advanced Methods
456
Metal ions can be separated from one another by complexation with organic ligands–the chelating agent– to form uncharged chelates. Here, the chelating agent must contain hydrophobic groups and behave as a weak acid, losing a proton to bind with the metal. Since most organic ligands used in this process are insoluble or undergo oxidation in the aqueous phase, the chelating agent is initially added to the organic phase and extracted into the aqueous phase. The metal-ligand complex is...
456
Washing, Drying, and Ignition of Precipitates
925
After filtration, the precipitate is washed to remove coprecipitated impurities and any remaining mother liquor. Colloidal precipitates, such as silver chloride, are washed with an electrolyte (such as dilute nitric acid) to prevent the peptization of the precipitate. In the case of slightly soluble precipitates, the wash solution contains a common ion to reduce solubility. Lead sulfate, which is slightly soluble in water, is washed with dilute sulfuric acid. Similarly, wash solutions may be...
925
