区域选择性和受控密度分支在粉中

Polymers are classified as linear or branched on the basis of their chain architecture. The polymer chains in linear polymers have a long chain-like structure with minimal to no branching at all. Even if a polymer features large substituent groups on the monomer, which appear as branches to the skeleton, it is not considered a branched polymer. A branched polymer contains secondary polymer chains that arise from the main polymer chain. The branching occurs when the polymer growth shifts from...

The skeletal structure of polymers synthesized via radical polymerization is always branched. For example, the polymerization of ethylene by radical polymerization results in a low-density grade of polyethylene with a heavily branched skeletal structure. Here, the radical site abstracts hydrogen from the growing chain, and the radical site shifts from the end (a primary carbon center) to anywhere within the growing chain (a secondary carbon center). Consequently, the part of the chain from the...

The rate of acid-catalyzed hydration of alkenes depends on the alkene's structure, as the presence of alkyl substituents at the double bond can significantly influence the rate.

If a set of reactants can yield multiple constitutional isomers, but one of the isomers is obtained as the major product, the reaction is said to be regioselective. In such reactions, bond formation or breaking is favored at one reaction site over others.
The hydrohalogenation of an unsymmetrical alkene can yield two haloalkane products, depending on which vinylic carbon takes up the halogen. However, one product usually predominates, where hydrogen adds to the vinylic carbon bearing the...

Crossed Claisen condensations are base-promoted reactions between two different ester molecules producing β-dicarbonyl compounds.  The reaction involving esters, with both containing α hydrogen, results in a mixture of four different products that are difficult to isolate. This reduces the synthetic utility of the reaction.

As depicted in the figure below, the unsymmetrical ketones can form two possible enolates:  less substituted or more substituted enolates. Usually, the thermodynamic enolates are formed from the more substituted α-carbon atom, while the kinetic enolates are formed faster by deprotonation from the less substituted position. The thermodynamic enolates have lower energy, so they are  more stable. But the energy required to form kinetic enolates is less.