通过移动框架的重新规范化的能量来实现Loewner能量

A reference frame accelerating or decelerating relative to an inertial frame is a non-inertial frame. To help understand this, consider what taking off in an airplane, turning a corner in a car, riding a merry-go-round, and the circular motion of a tropical cyclone all have in common. All these systems are accelerating, decelerating, or rotating relative to the Earth; hence, they all are non-inertial frames. All these systems exhibit inertial forces, which merely seem to arise from motion,...

The dynamics of a mechanical system can be easily understood by interpreting a potential energy diagram. Since energy is a scalar quantity, the interpretation of the dynamics of the system becomes even simpler.
Take the example of a skater on a parabolic ramp. The potential energy at different points along the ramp will be proportional to the height of the ramp, which varies quadratically with the horizontal position on the ramp. As the skater moves down the ramp from the highest position,...

Newton’s first law is usually considered to be a statement about reference frames. It provides a method for identifying a special type of reference frame: the inertial reference frame. In principle, we can make the net force on a body zero. If its velocity relative to a given frame is constant, then that frame is said to be inertial. So, by definition, an inertial reference frame is a reference frame where Newton's first law holds valid. Newton's first law applies to objects with...

The terms 'conserved quantity' and 'conservation law' have specific scientific meanings in physics, which differ from the meanings associated with their everyday use. For example, in everyday usage, water could be conserved by not using it, by using less of it, or by re-using it. However, in scientific terms, a conserved quantity of a system stays constant, changes by a definite amount that is transferred to other systems, and is converted into other forms of that...

When solving problems using the energy conservation law, the object (system) to be studied should first be identified. Often, in applications of energy conservation, we study more than one body at the same time. Second, identify all forces acting on the object and determine whether each force doing work is conservative. If a non-conservative force (e.g., friction) is doing work, then mechanical energy is not conserved. The system must then be analyzed with non-conservative work. Third, for...

The kinetic energy of a particle is one-half of the product of the particle’s mass and the square of its speed. Note that just as Newton’s second law can be expressed as either the rate of change of momentum or mass multiplied by the rate of change of velocity, so too can the kinetic energy of a particle be expressed in terms of its mass and momentum, instead of its mass and velocity.