相关实验视频

Updated: Aug 11, 2026

Quantitative Fundus Autofluorescence for the Evaluation of Retinal Diseases
07:22

Quantitative Fundus Autofluorescence for the Evaluation of Retinal Diseases

Published on: March 11, 2016

11.4K

在平坦中以拉芬的含量

Reham William Doss1, Esraa Hatem Ahmed Mohammed2, Eman Hamdy Mohamed3

  • 1Dermatology Department, Faculty of Medicine, Beni-Suef University, Mohammed Hassan Street, Beni Suef, Beni- Suef, 62511, Egypt. reham.doss@med.bsu.edu.eg.

Archives of dermatological research
|August 20, 2024
PubMed
概括

在患有状平原 (LP),一种自身免疫性皮肤疾病的患者中,elafin水平显著升高. 这一发现表明,elafin可能在LP病变发生的炎症过程中发挥作用.

关键词:
自身免疫性疾病是一种自身免疫性疾病.这种状状植物是平的.病变的发生和发病.

更多相关视频

Lipid Index Determination by Liquid Fluorescence Recovery in the Fungal Pathogen Ustilago Maydis10:22

Lipid Index Determination by Liquid Fluorescence Recovery in the Fungal Pathogen Ustilago Maydis

Published on: April 3, 2018

7.6K
Dermoscopy Aids in the Diagnosis of Discoid Lupus Erythematosus05:38

Dermoscopy Aids in the Diagnosis of Discoid Lupus Erythematosus

Published on: May 16, 2025

39

相关概念视频

Mixtures of Gases: Dalton's Law of Partial Pressures and Mole Fractions03:03

Mixtures of Gases: Dalton's Law of Partial Pressures and Mole Fractions

Unless individual gases chemically react with each other, the individual gases in a mixture of gases do not affect each other’s pressure. Each gas in a mixture exerts the same pressure that it would exert if it were present alone in the container. The pressure exerted by each individual gas in a mixture is called its partial pressure.
Henderson-Hasselbalch Equation02:48

Henderson-Hasselbalch Equation

The ionization-constant expression for a solution of a weak acid can be written as:
Ratio Level of Measurement00:54

Ratio Level of Measurement

The way a set of data is measured is called its level of measurement. Correct statistical procedures depend on a researcher being familiar with levels of measurement. For analysis, data are classified into four levels of measurement—nominal, ordinal, interval, and ratio.
A set of data measured using the ratio scale takes care of the ratio problem and provides complete information. Ratio scale data are like interval scale data, except they have a zero point and ratios can be calculated. For...
Fermi Level01:18

Fermi Level

The Fermi-Dirac function is represented by an S-shaped curve indicating the probability of an energy state being occupied by an electron at a given temperature. The Fermi level is the energy level at which there is a fifty percent chance of finding an electron, and it is positioned between the lower-energy valence band and the higher-energy conduction band.
At absolute zero temperature, electrons fill all energy states up to the Fermi level, leaving upper states empty. As the temperature rises,...
Specific Gravity of Aggregate01:19

Specific Gravity of Aggregate

Aggregates typically contain pores, which can be either permeable or impermeable. Considering the pores in the aggregates, the specific gravity of aggregates is defined in three different forms, namely, bulk or gross specific gravity, apparent specific gravity, and absolute specific gravity.
Bulk or gross specific gravity is calculated by taking the ratio of the mass of aggregates in the saturated surface-dry state to the total volume that includes both the solids and the voids within the...
Bulk Density of Aggregate01:22

Bulk Density of Aggregate

Bulk density refers to the mass of aggregate particles that would fill a unit volume. The concept of bulk density originates from the inability to pack aggregate particles in a manner that completely eliminates void spaces. Hence, the term bulk refers to the volume that encompasses both the aggregates and the voids. This measurement is crucial when aggregates are batched by volume and is used to convert quantities by mass to volume.
Most natural mineral aggregates, like sand and gravel,...