相关实验视频

Updated: Jun 14, 2025

Experimental Procedure for Warm Spinning of Cast Aluminum Components
07:36

Experimental Procedure for Warm Spinning of Cast Aluminum Components

Published on: February 1, 2017

9.5K

开发低压压Al-Zn-Mg-Cu合金螺旋第二部分:过程优化模拟

Min-Seok Kim1, Soonho Won2

  • 1Department of Materials Science and Engineering, Hanyang University, 222, Wangsimni-ro, Seongdong-gu, Seoul 04763, Republic of Korea.

Materials (Basel, Switzerland)
|August 29, 2024
PubMed
概括

这项研究优化了使用低压压 (LPDC) 的合金螺旋. 基于模拟的造参数调整显著减少了热撕裂和缺陷,改善了螺旋质量和结构完整性.

关键词:
这是一种Al-Zn-Mg-Cu合金.热撕裂 热撕裂 热撕裂低压压机 低压压机螺旋螺旋是一个螺旋.模拟模拟是指一个模拟模拟器.

更多相关视频

An Available Technique for Preparation of New Cast MnCuNiFeZnAl Alloy with Superior Damping Capacity and High Service Temperature14:51

An Available Technique for Preparation of New Cast MnCuNiFeZnAl Alloy with Superior Damping Capacity and High Service Temperature

Published on: September 23, 2018

6.9K
Indirect Fabrication of Lattice Metals with Thin Sections Using Centrifugal Casting08:32

Indirect Fabrication of Lattice Metals with Thin Sections Using Centrifugal Casting

Published on: May 14, 2016

12.5K

相关概念视频

Thin-Walled Hollow Shafts01:15

Thin-Walled Hollow Shafts

In analyzing a thin-walled hollow shaft subjected to torsional loading, a segment with width dx is isolated for examination. Despite its equilibrium state, this segment faces torsional shearing forces at its ends. These forces are quantitatively described by the product of the longitudinal shearing stress on the segment's minor surface and the area of this surface, leading to the concept of shear flow. This shear flow is consistent throughout the structure, indicating a uniform distribution...
176