相关实验视频
Updated: Jun 14, 2025

10:17
20 mJ, 1 ps Yb:YAG Thin-disk Regenerative Amplifier
Published on: July 12, 2017
11.5K
一个700千伏脉冲发电机,其上升时间大约为几纳秒
Junna Li1, Yongliang Wang1, Xiaoyu Zhou1
1State Key Laboratory of Electrical Insulation and Power Equipment, Xi'an Jiaotong University, Xi'an 710024, People's Republic of China.
The Review of scientific instruments
|September 6, 2024
概括
为电磁脉冲 (EMP) 环境测试开发了一种具有快速上升时间的新型高压脉冲发生器. 它实现了645千伏输出,证明了其评估动力设备保护的能力.
科学领域:
- 电气工程 电气工程
- 电磁学 电磁学 电磁学 电磁学
- 高电压工程 高电压工程
背景情况:
- 高海拔的电磁脉冲 (EMP) 环境对电源设备构成风险.
- 准确评估保护性能需要专门的脉冲发生器.
- 现有的发电机可能缺乏相应测试所需的电压和上升时间.
研究的目的:
- 设计和开发具有快速上升时间的高压脉冲发生器.
- 集成一个高时间分辨率的诊断系统,以进行准确的测量.
- 为了评估发电机对模拟高空EMP条件的性能.
主要方法:
- 一个新的脉冲发生器的设计,可能是马克思发生器配置.
- 整合一个能够实现纳秒级时间分辨率的诊断系统.
- 实验测试以测量在不同电容充电电压下输出电压和上升时间.
主要成果:
- 脉冲发生器在负载上达到645kV的最大输出电压.
- 输出脉冲的上升时间从8.2到9.9纳秒不等.
- 这些结果是用马克思发电机电容器充电电压在20kV至40kV之间得到的.
结论:
- 开发的脉冲发生器符合高电压和快速上升时间的要求.
- 它适用于在高海拔EMP环境中对电力设备保护的同等评估.
- 集成诊断系统为发电机的表征提供可靠的测量.
相关概念视频
NMR Spectrometers: Radiofrequency Pulses and Pulse Sequences
779
A pulse is a short burst of radio waves distributed over a range of frequencies that simultaneously excites all the nuclei in the sample. Upon passing a radio frequency pulse along the x-axis, the nuclei absorb energy corresponding to their Larmor frequencies and achieve resonance. This shifts the net magnetization vector from the z-axis toward the transverse plane. This angle of rotation of the magnetization vector, or the flip angle, is proportional to the duration and intensity of the pulse.
779
Generator Voltage Control
137
Generator voltage control is crucial for maintaining the stable operation of synchronous generators and wind turbines. In older models, a DC generator driven by the rotor delivers DC power to the rotor's field winding, and the power is transferred through slip rings and brushes. In the latest models, static or brushless exciters are used. Static exciters rectify AC power from the generator terminals and then transfer the DC power directly to the rotor. Brushless exciters, on the other hand,...
137
Van de Graaff Generator
1.7K
Van de Graaff generators (or Van de Graaffs) are devices used to demonstrate high voltage due to static electricity that can also be used for research. Robert Van de Graaff first built one in 1931 (based on original suggestions by Lord Kelvin) for use in nuclear physics research.
Van de Graaff uses both smooth and pointed surfaces, conductors, and insulators to generate large static charges and, hence, large voltages. A substantial excess charge can be deposited on the sphere because it moves...
Van de Graaff uses both smooth and pointed surfaces, conductors, and insulators to generate large static charges and, hence, large voltages. A substantial excess charge can be deposited on the sphere because it moves...
1.7K
Rectangular and Triangular Pulse Function
622
The unit rectangular pulse function is mathematically represented by a rectangular function centered at the origin with a height of one unit. This function is defined by two parameters: T, which specifies the center location of the pulse along the time axis, and τ, which determines the pulse duration.
For example, consider a rectangular pulse with a 5V amplitude, a 3-second duration, and centered at t=2 seconds. This pulse can be expressed using the rectangular function, written as,
For example, consider a rectangular pulse with a 5V amplitude, a 3-second duration, and centered at t=2 seconds. This pulse can be expressed using the rectangular function, written as,
622
Design Example: Capacitance Multiplier Circuit
730
In integrated circuit technology, a capacitance multiplier is often utilized to produce a larger capacitance value when a small physical capacitance falls short. This is achieved by a circuit that multiplies capacitance values by a factor of up to 1000, such that a 10-pF capacitor can replicate the performance of a 100-nF capacitor.
The circuit illustrated in Figure 1 below incorporates two op-amps, with the first operating as a voltage follower and the second acting as an inverting amplifier.
The circuit illustrated in Figure 1 below incorporates two op-amps, with the first operating as a voltage follower and the second acting as an inverting amplifier.
730
Voltage Doubler Circuit
504
A voltage doubler circuit integrates two main components: a clamping section and a rectifier section. The clamping section consists of a capacitor (C1) and a diode (D1), whereas the rectifier section is equipped with another diode (D2) and capacitor (C2). This circuit produces an output voltage with twice the amplitude of the sinusoidal input voltage.
504

