相关实验视频

Updated: Jun 13, 2025

Use of Galleria mellonella as a Model Organism to Study Legionella pneumophila Infection
12:30

Use of Galleria mellonella as a Model Organism to Study Legionella pneumophila Infection

Published on: November 22, 2013

40.3K

对影响菌和建筑物内部建筑物管道系统中总细胞生长的参数的统计分析:基于实证数据集的实地研究

Marco Daniele Genuardi1, Marlies Wiegand1, Elisabeth Endres2

  • 1Institute for the Transformation of the Energy System, West Coast University of Applied Sciences, Markt 18, 25746, Heide, Germany.

International journal of hygiene and environmental health
|September 14, 2024
PubMed
概括

长期停滞在建筑物中的水会促进病原体的生长,影响饮用水质量. 研究表明,在不稳定的系统中污染率更高,这表明改进的采样和超可以提高安全性.

关键词:
清洁的水 清洁的水危害健康的风险 健康风险公共卫生 公共卫生卫生设施 卫生设施 卫生设施超过的过方法水的停滞,就是水的停滞.

更多相关视频

Legionella pneumophila Outer Membrane Vesicles: Isolation and Analysis of Their Pro-inflammatory Potential on Macrophages08:34

Legionella pneumophila Outer Membrane Vesicles: Isolation and Analysis of Their Pro-inflammatory Potential on Macrophages

Published on: February 22, 2017

11.2K
Microfluidic Picoliter Bioreactor for Microbial Single-cell Analysis: Fabrication, System Setup, and Operation12:04

Microfluidic Picoliter Bioreactor for Microbial Single-cell Analysis: Fabrication, System Setup, and Operation

Published on: December 6, 2013

12.4K

相关概念视频

Design Example: Designing a Residential Plumbing System01:25

Design Example: Designing a Residential Plumbing System

The design of residential plumbing systems requires carefully evaluating water demand, flow rates, and pressure dynamics to ensure both efficiency and reliability. The nature of water flow within pipes is defined by its Reynolds number, which classifies flow as either laminar (smooth) or turbulent.
624
Single Pipe Systems01:24

Single Pipe Systems

In pipe flow analysis, problems are typically categorized into three types — Type I, Type II, and Type III — based on the known parameters and the desired outcome. Each type of problem addresses specific engineering requirements using fluid properties, pipe characteristics, and operational conditions.
In a Type I problem, fluid properties (density and viscosity), pipe characteristics (including diameter, length, and surface roughness), and the flow rate or average velocity are...
116