相关实验视频

Updated: Jul 3, 2026

Rapid and Low-cost Prototyping of Medical Devices Using 3D Printed Molds for Liquid Injection Molding
10:43

Rapid and Low-cost Prototyping of Medical Devices Using 3D Printed Molds for Liquid Injection Molding

Published on: June 27, 2014

19.8K

使用3D打印开发和生产儿童上肢自行车适配器

Barbora Kopová1, Martin Bakeš1, Martin Čížek2

  • 1Department of Industrial Engineering and Management, Faculty of Mechanical Engineering, University of West Bohemia, Univerzitní 2762/22, 301 00 Pilsen, Czech Republic.

Materials (Basel, Switzerland)
|October 16, 2024
PubMed
概括

这项研究开发了一种创新的上肢适配器,适用于1-3岁的先天性上肢缺陷的儿童,使骑自行车和体力活动更安全. 这种功能性,负担得起的设备增强了残疾儿童的流动性和信心.

关键词:
这是3D打印的3D打印.自行车适配器 自行车适配器儿童适配器适配器儿童适配器原型设计产品的设计.上肢适配器的适配器上肢假肢的使用方法

更多相关视频

3D Planning and Printing of Patient Specific Implants for Reconstruction of Bony Defects08:15

3D Planning and Printing of Patient Specific Implants for Reconstruction of Bony Defects

Published on: August 4, 2020

6.4K
Creation of a High-Fidelity, Low-Cost, Intraosseous Line Placement Task Trainer via 3D Printing11:45

Creation of a High-Fidelity, Low-Cost, Intraosseous Line Placement Task Trainer via 3D Printing

Published on: August 17, 2022

2.0K

相关概念视频

Changes in the Appendicular Skeleton with Age01:09

Changes in the Appendicular Skeleton with Age

The upper and lower limb initially develops as a small bulge called a limb bud, which appears on the lateral side of the early embryo. The upper limb bud appears near the end of the fourth week of development, with the lower limb bud appearing shortly after.
Initially, the limb buds consist of a core of mesenchyme covered by a layer of ectoderm. The ectoderm at the end of the limb bud thickens to form a narrow crest called the apical ectodermal ridge. This ridge stimulates the underlying...