校正:在南非实施口服暴露前预防:美国国际开发署支持的方案的案例研究

Essential infection prevention measures are based on the knowledge of the infection chain, the modes of transmission in healthcare settings, and the use of the best practices in all healthcare settings. Compulsory public reporting of healthcare-associated infection rates is needed to allow individuals and the community to make informed choices regarding selecting a healthcare facility.
The best practices for preventing healthcare-associated infections include hand hygiene, patient risk...

Transmission-based precautions are for patients infected or suspected to be infected (or colonized) with organisms posing a significant risk to others. The transmission precautions include airborne and protective environment precautions.
Airborne precautions:
Use airborne precautions when treating patients known or suspected to have diseases that spread through the air—for example, tuberculosis or measles. These organisms are present in smaller droplets expelled by an infected person and...

Transmission-based precautions are for patients known to be infected or suspected to be infected or colonized with organisms that pose a significant risk to others. Some transmission-based precautions include contact, enteric, and droplet.
Contact Precautions:
Contact precautions are the measures taken to prevent the transmission of infectious agents, especially epidemiologically important microorganisms such as MRSA or influenza, primarily transmitted through direct or indirect contact with an...

The pre-procedure steps of handwashing include removing jewelry and rolling up sleeves. However, many organizations allow staff to wear wedding rings.
The hand washing procedure itself includes the following steps. First, cover cuts, if any, on hands with a waterproof dressing. Cuts and abrasions can become contaminated with bacteria hindering the ability to clean the area thoroughly. In addition, repeated hand washing can worsen an injury.  The nails must be short and clean, without nail...

Agonists can bind with and activate receptors, resulting in the formation of drug-receptor complexes. Once formed, these complexes catalyze many biochemical processes at the cellular level and subsequently induce a pharmacologic response. The degree of response is directly proportional to the fraction of activated receptors, which in turn, depends on the concentration of the drug at the receptor site as well as the sensitivity of the receptor. An increase in the administered dose contributes to...

The potency of a drug is the measure of its ability to produce a biological response and can be compared by looking at the half-maximum effective concentration or EC50 values of different drugs. A lower EC50 value indicates higher potency of the drug. In the dose–response curve of two antihypertensive drugs, candesartan and irbesartan, a significant difference is observed in their EC50 values. A lower EC50 value for candesartan indicates that it is more potent than irbesartan, as it...