相关实验视频

Updated: May 21, 2025

A Method to Estimate Cadaveric Femur Cortical Strains During Fracture Testing Using Digital Image Correlation
09:34

A Method to Estimate Cadaveric Femur Cortical Strains During Fracture Testing Using Digital Image Correlation

Published on: September 14, 2017

7.4K

I-PREDICT第50个百分点男性有限元素模型:干的开发和验证

Zachary S Hostetler1, Drew DiSerafino2, Alex Kalmar-Gonzalo2

  • 1Elemance LLC, Winston-Salem, USA. zach.hostetler@elemance.com.

Annals of biomedical engineering
|March 18, 2025
PubMed
概括

开发了一种名为I-PREDICT的新型人体模型 (HBM),以更好地评估背后盔甲形创伤 (BABT) 的伤害. 这种经过验证的模型准确地预测了受伤风险,改善了个人防护设备 (PPE) 的评估.

关键词:
在盔甲后面,重的创伤.这是一个不的创伤.有限元素建模的模型.失能预测能力的预测.胸部损伤 胸部受伤

更多相关视频

Proximal Cadaveric Femur Preparation for Fracture Strength Testing and Quantitative CT-based Finite Element Analysis08:04

Proximal Cadaveric Femur Preparation for Fracture Strength Testing and Quantitative CT-based Finite Element Analysis

Published on: March 11, 2017

9.3K
Subject-specific Musculoskeletal Model for Studying Bone Strain During Dynamic Motion09:32

Subject-specific Musculoskeletal Model for Studying Bone Strain During Dynamic Motion

Published on: April 11, 2018

9.6K

相关概念视频

Members Made of Elastoplastic Material01:19

Members Made of Elastoplastic Material

The behavior of elastoplastic materials under bending stresses, particularly in structural members with rectangular cross-sections, is crucial for predicting material responses and understanding failure modes. Initially, when a bending moment is applied, the stress distribution across the section follows Hooke's Law and is linear and elastic. This distribution means the stress increases from the neutral axis to the maximum at the outer fibers, up to the elastic limit.
As the bending moment...
93
Plastic Deformations of Members with a Single Plane of Symmetry01:21

Plastic Deformations of Members with a Single Plane of Symmetry

When a structural member undergoes plastic deformation due to bending, it is crucial to understand the position of the neutral axis and the stress distribution. This member, characterized by a single plane of symmetry, exhibits a uniform stress distribution, with negative stress above the neutral axis and positive stress below. Notably, the neutral axis does not align with the centroid of the cross-section. This misalignment is typical in cases where the cross-section is not rectangular or...
85
Typical Model Studies01:30

Typical Model Studies

Fluid mechanics model studies often utilize scaled-down systems to predict fluid behavior in full-scale environments, such as river flows, dam spillways, and structures interacting with open surfaces. Maintaining Froude number similarity in river models is crucial, as it replicates surface flow features like wave patterns and velocities.
211