相关实验视频

Updated: May 20, 2025

Measuring Attention and Visual Processing Speed by Model-based Analysis of Temporal-order Judgments
13:00

Measuring Attention and Visual Processing Speed by Model-based Analysis of Temporal-order Judgments

Published on: January 23, 2017

9.8K

开发用于T1和T2值的估计方法,使用对比剂和凝固剂的放松性用于磁共振成像幻影

Hiroki Okada1, Norikazu Koori2,2, Hatsune Shimizu3

  • 1Department of Radiology, Chiba University Hospital, 1-8-1 Inohana, Chuo-ku, Chiba-shi, Chiba, 260-8677, Japan.

Radiological physics and technology
|March 24, 2025
PubMed
概括

研究人员现在可以准确估计磁共振成像 (MRI) 幻影T1和T2值. 使用对比剂放松度的新确定方程式简化了用于一致的MRI组织分析的幻影校准.

关键词:
磁共振成像 (MRI) 是一种磁共振成像.幻影 幻影是一个幻影.放松性 放松性 放松性这就是T1的价值.这就是T2值.

更多相关视频

A Tactile Automated Passive-Finger Stimulator TAPS19:44

A Tactile Automated Passive-Finger Stimulator TAPS

Published on: June 3, 2009

13.6K
Measurement & Analysis of the Temporal Discrimination Threshold Applied to Cervical Dystonia10:05

Measurement & Analysis of the Temporal Discrimination Threshold Applied to Cervical Dystonia

Published on: January 27, 2018

9.7K

相关概念视频

Choosing Between z and t Distribution01:25

Choosing Between z and t Distribution

The z and the Student t distribution estimate the population mean using the sample mean and standard deviation. However, to decide which distribution to use for a calculation, one needs to determine the sample size, the nature of the distribution, and whether the population standard deviation is known. If the population standard deviation is known and the population is normally distributed, or if the sample size is greater than 30, the z distribution is preferred. The Student t distribution is...
2.7K
Estimating Population Mean with Unknown Standard Deviation01:22

Estimating Population Mean with Unknown Standard Deviation

In practice, we rarely know the population standard deviation. In the past, when the sample size was large, this did not present a problem to statisticians. They used the sample standard deviation s as an estimate for σ and proceeded as before to calculate a confidence interval with close enough results. However, statisticians ran into problems when the sample size was small. A small sample size caused inaccuracies in the confidence interval.
William S. Gosset (1876–1937) of the...
7.6K
Comparing Experimental Results: Student's t-Test01:09

Comparing Experimental Results: Student's t-Test

The t-test is a statistical method used to compare the sample mean with a population mean or compare two means from two data sets. The test statistic is calculated from the standard deviation, mean, and number of measurements in the data set at a selected confidence interval and then compared to a table of critical values at this confidence level. If the test statistic is smaller than the critical value, the null hypothesis is accepted. In this case, we state that the difference between the...
1.4K
Student t Distribution01:31

Student t Distribution

The population standard deviation is rarely known in many day-to-day examples of statistics. When the sample sizes are large, it is easy to estimate the population standard deviation using a confidence interval, which provides results close enough to the original value. However, statisticians ran into problems when the sample size was small. A small sample size caused inaccuracies in the confidence interval.
The Student t distribution was developed by William S. Goset (1876–1937) of the...
5.8K
Distributions to Estimate Population Parameter01:26

Distributions to Estimate Population Parameter

The accurate values of population parameters such as population proportion, population mean, and population standard deviation (or variance) are usually unknown. These are fixed values that can only be estimated from the data collected from the samples. The estimates of each of these parameters are sample proportion, the sample mean, and sample standard deviation (or variance). To obtain the values of these sample statistics, data are required that have particular distribution and central...
4.0K
Confidence Interval for Estimating Population Mean01:25

Confidence Interval for Estimating Population Mean

A point estimate of the population mean is obtained from a single sample. Such a point estimate does not represent a population well because it needs to account for variability in the population. Single point estimate can also be biased despite the sample being selected randomly. Thus, a point estimate is often unreliable. A confidence interval is needed to reduce this unreliability.
A confidence interval for the mean is a range of values that provides an estimate of the population mean. As the...
7.2K