开发一个小瓶尺度的方法来测量使用蒸发性结晶的核动力学:一个用化的案例研究
Michele Chen1, Leif-Thore Deck1, Luca Bosetti1
1Institute of Energy and Process Engineering, ETH Zürich, 8092 Zürich, Switzerland.
Crystal growth & design
|April 21, 2025
概括
这项研究提出了一种新的蒸发方法来测量核化动力学,这对于结晶过程至关重要. 这种技术适用于所有化合物,与传统的冷却方法不同.
科学领域:
- 结晶科学 结晶科学
- 物理化学 物理化学
- 材料科学 材料科学 材料科学
背景情况:
- 核化动力学对于控制结晶过程至关重要.
- 传统的基于冷却的方法对于具有温度独立可溶性的化合物是有限的.
- 需要一种强大的方法来测量各种化合物的核化动力学.
研究的目的:
- 引入和验证一种实验程序,用于测量使用蒸发性结晶的核化动力学.
- 将该方法应用于化 (NaCl) 在水溶液中的核化.
- 为了证明蒸发性结晶对于核化研究的适用性,而不考虑溶解度与温度的依赖性.
主要方法:
- 开发了一种用于蒸发性结晶的实验装置.
- 系统地改变了温度和蒸发气体流速等参数.
- 收集了有关化核化的全面数据.
主要成果:
- 成功获得化的详细核化数据.
- 估计的动力参数使用从古典核化理论 (CNT) 衍生的速率表达式.
- 在各种实验条件下证明了该方法的有效性.
结论:
- 蒸发性结晶是一种强大的和多功能方法来测量核化动力学.
- 该技术克服了温度依赖溶解度的局限性.
- 这种方法推进了对更广泛的化合物的结晶过程的设计和控制.
相关概念视频
Recrystallization: Solid–Solution Equilibria
987
Recrystallization is a purification technique used to separate impurities from solid compounds. In this technique, no chemical reactions occur. Instead, it exploits physical properties only, specifically, the solubility differences between the desired compound and impurities, either at a single temperature or at different temperatures, and under other selected conditions. The solid-solution equilibrium (solubility equilibrium) of each component in the solution represents a binary phase...
987
Volatilization
319
Volatilization gravimetry is an analytical technique that measures the mass lost due to the volatilization of the substance. This technique is used to estimate the amount of volatile material in a sample. To perform this method, heat a known amount of the sample to a high temperature in a crucible or other suitable vessel. The volatile substance in the sample evaporates, and the vapor is completely expelled from the crucible either by heating the sample or bubbling a stream of inert gas through...
319
Crystal Growth: Principles of Crystallization
1.4K
Crystallization is a phase transformation process in which crystals are precipitated from a supersaturated solution or formed from other sources. During crystallization, atoms or molecules arrange themselves into a well-defined, rigid crystal lattice to minimize energy.
Initiating crystallization involves manipulating the concentration of the solute and the temperature of the solution. Since crystal growth occurs when the ratio of concentration and solubility of the solute in the solvent...
Initiating crystallization involves manipulating the concentration of the solute and the temperature of the solution. Since crystal growth occurs when the ratio of concentration and solubility of the solute in the solvent...
1.4K
Washing, Drying, and Ignition of Precipitates
772
After filtration, the precipitate is washed to remove coprecipitated impurities and any remaining mother liquor. Colloidal precipitates, such as silver chloride, are washed with an electrolyte (such as dilute nitric acid) to prevent the peptization of the precipitate. In the case of slightly soluble precipitates, the wash solution contains a common ion to reduce solubility. Lead sulfate, which is slightly soluble in water, is washed with dilute sulfuric acid. Similarly, wash solutions may be...
772
Precipitation Titration Curve: Analysis
960
The precipitation titration curve demonstrates the change in concentration of one reactant with the volume of titrant added. During the titration of chloride ions with silver nitrate, the precipitation titration curve is divided into three regions: before, at, and after the equivalence point. Before the equivalence point, low redissolution of the sparingly soluble silver chloride precipitate gives a low silver ion concentration. However, in the second region, representing the equivalence point,...
960
Precipitate Formation and Particle Size Control
611
In precipitation gravimetry, the precipitating agent should react specifically or selectively with the analyte. While a specific reagent reacts with the analyte alone, a selective reagent can react with a limited number of chemical species.
The obtained precipitate should be either a pure substance of known composition or easily converted to one by a simple process, such as ignition or drying. In addition, the precipitate should be insoluble and easily filterable. In general, filterability...
The obtained precipitate should be either a pure substance of known composition or easily converted to one by a simple process, such as ignition or drying. In addition, the precipitate should be insoluble and easily filterable. In general, filterability...
611


