基于弹性使用时间和唾液pH度的乳和非乳弹性带的强度衰变差异:实验室研究:
Rasdiana Bakri1, Baharuddin M Ranggang1, Nasyrah Hidayati1
1Department of Orthodontics, Faculty of Dentistry, Hasanuddin University, Indonesia.
Journal of orthodontic science
|April 30, 2025
概括
非乳弹性带比乳带的强力衰变更大,特别是在较低的pH值环境中. 强力衰变在使用的最初24小时内最为显著.
科学领域:
- 生物材料科学 生物材料科学
- 牙科材料科学 牙科材料科学
背景情况:
- 弹性带在正牙治疗中至关重要.
- 了解材料降解是治疗疗效的关键.
研究的目的:
- 为了比较乳和非乳弹性带之间的力衰变.
- 为了研究持续时间和唾液pH对力衰变的影响.
主要方法:
- 80条弹性带 (乳和非乳) 被分为四组.
- 样品被浸泡在37°C的人造唾液 (pH5.2和6.7) 中.
- 力量大小是用数字力度表随时间的推移而测量的.
主要成果:
- 最大力衰变发生在24小时内,稳定72小时.
- 较低的唾液pH (5.2) 导致乳和非乳带的力量衰变更大.
- 与乳带相比,非乳带在测试条件下表现出更高的力衰变.
结论:
- 材料类型 (乳与非乳) 显著影响弹性带力衰变.
- 唾液pH影响力衰变的速度,pH值较低加速降解.
- 非乳材料更容易受到强力衰变的影响,特别是在酸性环境中.
相关概念视频
Plastic Behavior
175
A material's elastic behavior is characterized by the disappearance of stress once the load is removed, allowing the material to return to its original state. However, when stress surpasses the yield point, yielding commences, marking the onset of plastic deformation or permanent set. This change from elastic to plastic behavior is influenced by the peak stress value and the duration before the load is removed. An intriguing observation occurs when a specimen is loaded, unloaded, and...
175
Buffer Effectiveness
48.2K
Buffer solutions do not have an unlimited capacity to keep the pH relatively constant . Instead, the ability of a buffer solution to resist changes in pH relies on the presence of appreciable amounts of its conjugate weak acid-base pair. When enough strong acid or base is added to substantially lower the concentration of either member of the buffer pair, the buffering action within the solution is compromised.
The buffer capacity is the amount of acid or base that can be added to a given volume...
The buffer capacity is the amount of acid or base that can be added to a given volume...
48.2K
Elasticity in Concrete
72
Upon subjecting concrete to moderate or high uniaxial compressive or tensile stresses, the strain response is non-linear relative to the stress applied. As the stress is removed, the resulting stress-strain curve deviates from the original path traced during loading, creating a hysteresis loop, indicative of the concrete's non-linear and non-elastic properties. Typically, a material's modulus of elasticity, which is a measure of the material's stiffness, is inferred from the linear...
72


