相关实验视频

Updated: May 9, 2025

Minimally Invasive Treatment for Thoracolumbar Burst Fracture Using Sagittal Alignment Screws and A Trauma Reduction Device
04:19

Minimally Invasive Treatment for Thoracolumbar Burst Fracture Using Sagittal Alignment Screws and A Trauma Reduction Device

Published on: November 8, 2024

318

重度硬脊椎病的三杆构造方法:一个全面的病例系列

Thirumurugan Kurusamy1, Mohamed Faizal B Abdul Manan1, Dzulkarnain Amir1

  • 1Department of Orthopedic Surgery, General Hospital Kuala Lumpur, Kuala Lumpur, MYS.

Cureus
|May 2, 2025
PubMed
概括

三棒技术有效地纠正严重的刚性脊,显著改善脊柱对齐,降低并发症风险. 这种方法为复杂的脊柱形提供了稳定的解决方案.

关键词:
角区域的纠正正确的是全球脊柱重新调整刚性脊柱形脊椎病是什么?脊柱变形纠正 脊柱变形纠正三杆杆的技术是三杆的.

更多相关视频

Modified Posterior Vertebral Column Resection for Patients with Thoracolumbar Kyphotic Deformity06:45

Modified Posterior Vertebral Column Resection for Patients with Thoracolumbar Kyphotic Deformity

Published on: September 16, 2022

2.1K
Three-dimensional Navigation-guided, Prone, Single-position, Lateral Lumbar Interbody Fusion Technique08:38

Three-dimensional Navigation-guided, Prone, Single-position, Lateral Lumbar Interbody Fusion Technique

Published on: July 15, 2021

3.2K

相关概念视频

Statically Indeterminate Problem Solving01:16

Statically Indeterminate Problem Solving

Statically indeterminate problems are those where statics alone can not determine the internal forces or reactions. Consider a structure comprising two cylindrical rods made of steel and brass. These rods are joined at point B and restrained by rigid supports at points A and C. Now, the reactions at points A and C and the deflection at point B are to be determined. This rod structure is classified as statically indeterminate as the structure has more supports than are necessary for maintaining...
339
Temperature Dependent Deformation01:12

Temperature Dependent Deformation

In a nonhomogeneous rod made up of steel and brass, restrained at both ends and subjected to a temperature change, several steps are involved in calculating the stress and compressive load. Due to the problem's static indeterminacy, one end support is disconnected, allowing the rod to experience the temperature change freely. Next, an unknown force is applied at the free end, triggering deformations in the rod's steel and brass portions. These deformations are then calculated and added...
121
Deformation of Member under Multiple Loadings01:11

Deformation of Member under Multiple Loadings

When a rod is made of different materials or has various cross-sections, it must be divided into parts that meet the necessary conditions for determining the deformation. These parts are each characterized by their internal force, cross-sectional area, length, and modulus of elasticity. These parameters are then used to compute the deformation of the entire rod.
In the case of a member with a variable cross-section, the strain is not constant but depends on the position. The deformation of an...
121