相关实验视频
Updated: Jan 16, 2026

06:00
Determination of the Settling Rate of Clay/Cyanobacterial Floccules
Published on: June 11, 2018
7.4K
淡水盐度对悬浮沉积物沉积在不同的高度事件期间的影响
Mengmeng Li1, Qizhong Guo2, Liang Chen1
1State Key Laboratory of Hydraulic Engineering Intelligent Construction and Operation, Tianjin University, Tianjin, 300350, PR China; School of Civil Engineering, Tianjin University, Tianjin, 300350, PR China.
Environmental pollution (Barking, Essex : 1987)
|October 2, 2025
概括
度的增加最初会在高度事件 (HTEs) 中减缓沉积物的沉积,这是由于液体密度和粘度. 然而,较高的盐度和悬浮沉积物度 (SSCs) 最终会加速总体沉降.
科学领域:
- 环境科学 环境科学
- 水资源管理 水资源管理
- 沉积物学的沉积物学
背景情况:
- 高度事件 (HTEs) 影响水生生态系统.
- 了解不同盐度下沉积物沉积动态对于风险评估至关重要.
研究的目的:
- 为了研究轻度盐度 (0-2 ppt) 对悬浮沉积物在HTE期间沉积的影响.
- 确定初始悬浮沉积物度 (SSCs) 如何影响与盐度相关的沉降率.
主要方法:
- 进行了水立静态沉降实验.
- 盐度水平从0.3到2.0mS/cm (EC) 不同.
- 最初的SSC范围从400到1200NTU.
主要成果:
- 度增加最初抑制了沉速度 (44-600分钟),这是由于液体密度和粘度.
- 更高的SSC也推迟了初始结算率的改善.
- 总体而言,盐度和SSC的增加加速了沉积物的沉积.
- 度降低率与盐度和SSC正相关.
- 在非常高的SSC (≥1200NTU) 时,低盐度 (≤0.8mS/cm) 的加速效应是最小的.
结论:
- 盐度对高温体验期间的沉积物产生双重影响:最初的抑制,然后是整体加速.
- 盐度和SSC都是影响水中沉积物运输和沉积的关键因素.
相关概念视频
Colloidal precipitates
5.2K
The high insolubility of some precipitates can result in an unfavorable relative supersaturation. This can lead to colloidal particles with a large surface-to-mass ratio, where adsorption is promoted. For instance, in the precipitation of silver chloride, silver ions are adsorbed on the surface of the colloidal particles, forming a primary layer. This layer attracts ions of opposite charge (such as nitrate ions), forming a diffuse secondary layer of adsorbed ions. This electric double layer...
5.2K
Precipitate Formation and Particle Size Control
5.6K
In precipitation gravimetry, the precipitating agent should react specifically or selectively with the analyte. While a specific reagent reacts with the analyte alone, a selective reagent can react with a limited number of chemical species.
The obtained precipitate should be either a pure substance of known composition or easily converted to one by a simple process, such as ignition or drying. In addition, the precipitate should be insoluble and easily filterable. In general, filterability...
The obtained precipitate should be either a pure substance of known composition or easily converted to one by a simple process, such as ignition or drying. In addition, the precipitate should be insoluble and easily filterable. In general, filterability...
5.6K
Factors Affecting Solubility
36.7K
Compared with pure water, the solubility of an ionic compound is less in aqueous solutions containing a common ion (one also produced by dissolution of the ionic compound). This is an example of a phenomenon known as the common ion effect, which is a consequence of the law of mass action that may be explained using Le Chȃtelier’s principle. Consider the dissolution of silver iodide:
36.7K
Ionic Strength: Effects on Chemical Equilibria
2.5K
The addition of an inert ionic compound increases the solubility of a sparingly soluble salt. For example, adding potassium nitrate to a saturated solution of calcium sulfate significantly enhances the solubility of calcium sulfate. Le Châtelier's principle cannot predict this shift in the equilibrium. Instead, this could be explained in terms of changes in the effective concentration of the ions in solution in the presence of added inert salt.
In this solution, the primary...
In this solution, the primary...
2.5K
Coagulation
1.2K
Colloidal solids are solid particles suspended in solution. They are usually negatively charged, attracting a compact primary layer of positively charged ions, which attract more counterions to form an electrical double layer. Electrostatic repulsion between the charged double layers prevents the particles from colliding, stabilizing the colloids. These solids are often undesirable because they can contain toxins that are difficult to remove. Coagulation is a technique that helps aggregate and...
1.2K
Precipitation and Co-precipitation
4.0K
Precipitation and coprecipitation methods can be used to separate a mixture of ions in a solution. In qualitative inorganic analysis, ions that form sparingly soluble precipitates with the same reagent are separated based on the differences in solubility products. For example, consider the separation of Cu(II) and Fe(II) ions by precipitation as insoluble sulfides. First, copper(II) sulfide is precipitated by the addition of acidic H2S, where the dissociation of H2S is suppressed. Adding H2S...
4.0K

