相关实验视频

Updated: Jan 23, 2026

Minimally Invasive Establishment of Murine Orthotopic Bladder Xenografts
08:15

Minimally Invasive Establishment of Murine Orthotopic Bladder Xenografts

Published on: February 11, 2014

16.4K

响应度,最小可检测的变化和最小临床重要差异的土耳其版本的8项过度活跃的膀问卷

Seyda Toprak Celenay1, Erhan Secer2, Yasemin Karaaslan3

  • 1Faculty of Health Sciences, Department of Physiotherapy and Rehabilitation, Ankara Yildirim Beyazit University, Ankara, Türkiye.

International urogynecology journal
|January 22, 2026
PubMed
概括

土耳其过度活跃膀问卷 (OAB-V8) 显示了OAB女性的良好反应和区分能力. 这种经过验证的工具有助于临床医生跟踪治疗的有效性和临床相关性.

关键词:
过度活动的膀.患者报告的结果衡量结果.骨盆底疾病 骨盆底疾病心理测量 心理测量 心理测量在ROC曲线上,ROC曲线

更多相关视频

Through-the-Wall Blood Sampling Method to Minimize Sleep Disruption in Clinical Settings06:39

Through-the-Wall Blood Sampling Method to Minimize Sleep Disruption in Clinical Settings

Published on: June 13, 2025

446
External Cephalic Version: Is it an Effective and Safe Procedure?08:49

External Cephalic Version: Is it an Effective and Safe Procedure?

Published on: June 6, 2020

15.8K

相关概念视频

Types of Errors: Detection and Minimization01:12

Types of Errors: Detection and Minimization

Error is the deviation of the obtained result from the true, expected value or the estimated central value. Errors are expressed in absolute or relative terms.
Absolute error in a measurement is the numerical difference from the true or central value. Relative error is the ratio between absolute error and the true or central value, expressed as a percentage.
Errors can be classified by source, magnitude, and sign. There are three types of errors: systematic, random, and gross.
Systematic or...
10.8K
Difference from Background: Limit of Detection01:05

Difference from Background: Limit of Detection

The limit of detection (LOD) is the smallest amount of analyte that can be distinguished from the background noise. The LOD value corresponds to the concentration at which the analyte signal is three times larger than the standard deviation of the blank signal. Below this value, the analyte signal cannot be differentiated from the background noise. It is calculated by dividing the calibration slope by 3 times the standard deviation of the blank signals.
The LOD indicates the presence or absence...
8.1K
Le Chatelier's Principle: Changing Concentration02:27

Le Chatelier's Principle: Changing Concentration

A system at equilibrium is in a state of dynamic balance, with forward and reverse reactions taking place at equal rates. If an equilibrium system is subjected to a change in conditions that affects these reaction rates differently (a stress), then the rates are no longer equal and the system is not at equilibrium. The system will subsequently experience a net reaction in the direction of a greater rate (a shift) that will re-establish the equilibrium. This phenomenon is summarized by Le...
65.3K
Le Chatelier's Principle: Changing Volume (Pressure)02:32

Le Chatelier's Principle: Changing Volume (Pressure)

For gas-phase equilibria, changes in the concentrations of reactants and products can occur with altered volume and pressure. The partial pressure, P, of an ideal gas is proportional to its molar concentration, M.
40.3K
Le Chatelier's Principle: Changing Temperature02:19

Le Chatelier's Principle: Changing Temperature

Consistent with the law of mass action, an equilibrium stressed by a change in concentration will shift to re-establish equilibrium without any change in the value of the equilibrium constant, K. When an equilibrium shifts in response to a temperature change, however, it is re-established with a different relative composition that exhibits a different value for the equilibrium constant.
To understand this phenomenon, consider the elementary reaction:
35.1K
Standard Entropy Change for a Reaction03:00

Standard Entropy Change for a Reaction

Entropy is a state function, so the standard entropy change for a chemical reaction (ΔS°rxn) can be calculated from the difference in standard entropy between the products and the reactants.
24.1K