在单细胞中从高吞吐量长读单细胞转录组中发现了融合基因

Cancer arises from mutations in the critical genes that allow healthy cells to escape cell cycle regulation and acquire the ability to proliferate indefinitely. Though originating from a single mutation event in one of the originator cells, cancer progresses when the mutant cell lines continue to gain more and more mutations, and finally, become malignant. For example, chronic myelogenous leukemia (CML) develops initially as a non-lethal increase in white blood cells, which progressively...

Multicellular organisms contain a variety of structurally and functionally distinct cell types, but the DNA in all the cells originated from the same parent cells. The differences in the cells can be attributed to the differential gene expression. Liver cells, whose functions include detoxification of blood, production of bile to metabolize fats, and synthesis of proteins essential for metabolism, must express a specific set of genes to perform their functions. Gene expression also varies with...

The process of converting very light nuclei into heavier nuclei is also accompanied by the conversion of mass into large amounts of energy, a process called fusion. The principal source of energy in the sun is a net fusion reaction in which four hydrogen nuclei fuse and ultimately produce one helium nucleus and two positrons.
A helium nucleus has a mass that is 0.7% less than that of four hydrogen nuclei; this lost mass is converted into energy during the fusion. This reaction produces about...

In structural engineering, the analysis of beams subjected to varying loads is a critical aspect of understanding the behavior and performance of these structural elements. A common scenario involves a beam subjected to a combination of different load distributions.
Consider a beam of length L subjected to a varying load, which is a combination of parabolic and trapezoidal load distribution along the x-axis. In this case, it is essential to determine the resultant loads, their locations, and...

In pipe flow analysis, problems are typically categorized into three types — Type I, Type II, and Type III — based on the known parameters and the desired outcome. Each type of problem addresses specific engineering requirements using fluid properties, pipe characteristics, and operational conditions.
In a Type I problem, fluid properties (density and viscosity), pipe characteristics (including diameter, length, and surface roughness), and the flow rate or average velocity are...